[asterisk-ss7] libss7 - stp point codes

Matthew Fredrickson creslin at digium.com
Sat Jun 14 13:25:07 CDT 2008

Tom Chandler wrote:
> on going testing:  Question:
> In an ANSI setup, I have two A-Links.  One to each of the mated STP's.
> in the zapata.conf, the  adjpointcode (if I read it right) is for the STP point code.
> I have a different point code for each STP.  Can you or How would you load 
> both of these point codes into the configuration file.

It's kind of a non intuitive interface for doing so, but this is how it 
is done:

sigchan=24 ; or whatever the first link is
sigchan=48 ; or whatever the second link is

Matthew Fredrickson
Software/Firmware Engineer
Digium, Inc.

More information about the asterisk-ss7 mailing list