[asterisk-dev] BRI support in chan_zap of asterisk 1.6?

[Mark Elkins]

On Sun, 2008-03-09 at 17:42 -1000, Jean-Denis Girard wrote:
> Matt Riddell a écrit :
> > Meaning you don't get echo using asterisk-1.6.0, zaptel-1.4,
> > libpri-trunk, and Junghanns's zaphfc driver (patched with bri_dchan)
> 
> Yes, exactly, sorry if that was not clear from my previous post. I've 
> used this setup since, and it works fine, but its just a soho system, 
> very low volume of calls. I had echo problems with chan_misdn on the 
> same system. I hope Digium will continue this BRI effort.

Just like to add a "Me too"...

I've used a Junghanns card and software patch for years - its always
worked well.

When setting up systems for others - its been with a mix of mISDN - etc
- and never been a complete success..

I am *so* looking forward to a consolidated Digium based ISDN BRI
solution. This will be the main reason for me to move to Asterisk 1.6

-- 
  .  .     ___. .__      Posix Systems - Sth Africa
 /| /|       / /__       mje at posix.co.za  -  Mark J Elkins, Cisco CCIE
/ |/ |ARK \_/ /__ LKINS  Tel: +27 12 807 0590  Cell: +27 82 601 0496