[Asterisk-Dev] Zap Circuit Status via Manager

[Brian Wilkins]

http://www.voip-info.org/wiki-asterisk+manager+events

Alarm:
    [derived from chan_zap.c]

    Event: Alarm
    Alarm: <(Red|Yellow|Blue|No|Unknown) Alarm|Recovering|Loopback|Not Open|
None>
    Channel: <channel>


AlarmClear:
    [derived from chan_zap.c]

    Event: AlarmClear
    Channel: <channel>


On Thursday 16 December 2004 12:16 pm, Ben Merrills wrote:
> IS there any way of getting the status of Zap circuit from the manager
> interface? If not, as I think there isn't where would be the best place
> to implement this? Is the information available from within the asterisk
> architecture?
>
> Would be good if there was: -
>
> a) A manager event for if an alarm is set on a specific circuit
> Event: ZapAlarm
> Interface: Zap/1
> Alarm: Red
> Reason: No circuit detected
>
> b) A manager command, something like ZapStatus
> Action: ZapStatus
> Interface: Zap/1
>
> If any of this possible from within asterisk? Would this be located in
> chan_zap?
>
> Cheers,
>
> Ben Merrills
> _______________________________________________
> Asterisk-Dev mailing list
> Asterisk-Dev at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-dev
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-dev

-- 
Brian Wilkins
Software Engineer
brian at hcc.net

Heritage Communications Corporation
  Melbourne, FL     USA     32935
321.308.4000 x33
http://www.hcc.net