[asterisk-bugs] [JIRA] (ASTERISK-23462) Cannot disable SIP debugging via CLI after enabling with conf file option - also 'sip set debug off' reports debugging disabled, when it really isn't

[Rusty Newton (JIRA)]

    [ https://issues.asterisk.org/jira/browse/ASTERISK-23462?page=com.atlassian.jira.plugin.system.issuetabpanels:comment-tabpanel&focusedCommentId=219408#comment-219408 ] 

Rusty Newton commented on ASTERISK-23462:
-----------------------------------------

I'd expect it to turn debugging back on after parsing the config file again. I think having it respect the CLI command through reloads would make things too confusing. At least, that behavior would make sense.

At a minimum, it would be cool if the command didn't report "SIP Debugging Disabled" when it really isn't disabled.

If you happen to work on any of this, thanks in advance.  I think this issue is more of an annoyance than anything else.

> Cannot disable SIP debugging via CLI after enabling with conf file option - also 'sip set debug off' reports debugging disabled, when it really isn't
> -----------------------------------------------------------------------------------------------------------------------------------------------------
>
>                 Key: ASTERISK-23462
>                 URL: https://issues.asterisk.org/jira/browse/ASTERISK-23462
>             Project: Asterisk
>          Issue Type: Bug
>      Security Level: None
>          Components: Channels/chan_sip/General, Core/Logging
>    Affects Versions: SVN, 12.1.0
>            Reporter: Rusty Newton
>            Severity: Trivial
>
> This is trivial, but annoying.
> h1. Problem:
> With "sipdebug=yes" set in sip.conf, SIP debugging is enabled to the console.
> Running "sip set debug off" reports:
> {noformat}
> newtonr-laptop*CLI> sip set debug off
> SIP Debugging Disabled
> {noformat}
> However, SIP debugging continues to show up.
> h1. Thoughts:
> Ideally, "sipdebug=yes" would only affect the initial state of SIP debugging when Asterisk parses the config file and loads chan_sip. Then I would expect that you could affect the state of debugging with CLI commands while working on the CLI later on. Instead it appears to override the CLI commands completely.
> If we leave this behavior we should note it in the sip.conf and on the wiki, though I'd consider it a bug that the CLI command is reporting the state falsely.
> 1. Fix it so that the CLI commands can change the SIP debugging state despite the initial state upon load.
> 2. Or, document the behavior of sipdebug=yes acting as a permanent override and fix the false report from the CLI command.



--
This message was sent by Atlassian JIRA
(v6.2#6252)