[Asterisk-bsd] Can't Configure X100P card

[Josh Tipping]

I also forgot to mention that you should be using 'fxsks=1' rather than fxoks signalling.
      _____  

  From: Josh Tipping [mailto:josh at jtcomputers.biz]
To: Asterisk on BSD discussion [mailto:asterisk-bsd at lists.digium.com]
Sent: Wed, 04 Oct 2006 11:11:31 +1000
Subject: Re: [Asterisk-bsd] Can't Configure X100P card

  
Frank,  
   
'Red is Dead', i.e., RED means that no active PSTN line is detected, for starters. Have you connected an active PSTN line? If so, check your connections or try a different cable.  
   
Once thats done, run zttool, highlight your card, hit F1 and you should see 'no alarms'. If so, you're good to go.  
   
Josh Tipping.  
www.jtcomputers.biz/asterisk/
      _____  

  From: Frank Griffith [mailto:glassdude45 at yahoo.com]
To: asterisk-bsd at lists.digium.com
Sent: Wed, 04 Oct 2006 10:14:40 +1000
Subject: [Asterisk-bsd] Can't Configure X100P card

  
I run FreeBSD-6.0 and Asterisk-1,2,9,1. I purchased an X100P card and it arrived today. I installed it and to my surprise FreeBSD found it on IRQ9. When I loaded the zaptel drivers this appeared on my monitor:  
   
Zapata Telephony Interface Registered on major 196
Echo Canceller: MARK3
ZapTel device: vendor=e159 device=1 subvendor=8085
wcfxo0: <Wildcard X101P> port 0x6800-0x68ff mem 0xe4000000-0xe4000fff irq 9 at device 11.0 on pci0
ZapTel Attach for wcfxo0: deviceID : 0xe159
wcfxo0: [FAST]
wcfxo: DAA mode is 'FCC'
Found a Wildcard FXO: Wildcard X101P
ZapTel device loaded.
ztdummy: loaded  
   
I followed the instructions in the Asterisk TFOT manual and did the following to my zaptel.conf file:  
   
fxoks=2  
loadzone=us  
defaultzone=us  
   
I then restart Asterisk and try to configure the card using zttool. I see two entries, a RED and UNCONFIGURED. No matter which one I choose, it doesn't give me a clue as to what I should do. No man page is available for either zttool or ztcfg. Can anyone offer some advice here. It looks like it's trying to work I just can't get the channel to show up.  
   
ztcfg shows 0 channels configured.  

    _____  

  Stay in the know. Pulse on the new Yahoo.com. Check it out.   
   
       
   
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-bsd/attachments/20061003/5ce162c8/attachment.htm