[Asterisk-bsd] WCT1xxP driver

[Jason T. Nelson]

In our last exciting episode, Alexander Timoshenko (gonzo at univ.kiev.ua) said:
>     My fault. Forgot to remove debug output. Get the current version.

I completely wiped my old zaptel build to be sure, then downloaded the 
latest version via svn, but I still see the same repeating debug messages in 
/var/log/messages. Is there another source I am not familiar with?

>     You should build asterisk against libpri from CVS. Older version had
> wrong byte order detection, they will not work. I've made libpri 1.0.1 port
> with given patch, but it is not commited yet. 

Same procedure as above.. wiped libpri 1.0.2 and asterisk clean from my
system, then started from scratch, downloading libpri and asterisk from CVS
this morning (3 Nov 2004), still same effect. ztcfg doesn't report any
problems, zttool reports no alarms, but "pri show span 1" reports the
status:

*CLI> pri show span 1
Primary D-channel: 24
Status: Provisioned, Down, Active

This PRI works perfectly on a Cisco 5300, incidentally. Are there other
concerns that I could look at, perhaps the card rev? I should also add
this is under FreeBSD 5.2.1.

-- 
Jason T. Nelson <jtn at jtn.cx>                     http://www.jtn.cx/~jtn/
BOFH Extraordiaire & Sysadmin Ombudsman               GPG key 0xFF676C9E
GPG key fingerprint = 6272 5482 EDDD D0A3 FED2  262A FABB 599D FF67 6C9E
disclaimer: My opinions are my own. Don't bother my employer about them.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 230 bytes
Desc: not available
Url : http://lists.digium.com/pipermail/asterisk-bsd/attachments/20041103/b7d05e5e/attachment.pgp