[asterisk-biz] RE: [Asterisk-Users] OT: AudioCodes
MP124-C/FSX/AC/SIP
Toke
asterisk at nexus-sistemas.net
Fri May 26 03:26:26 MST 2006
Hi Michael,
Excellent guide and very well explained.
Do you have any other guide about interconnection with Audiocodes FXO and
PRI devices?
Regards
On 25/5/06 06:30, "The VoIP Connection" <asterisk-biz at thevoipconnection.com>
wrote:
> Here are the step by step instructions for setting up a brand new Audiocodes
> FXS gateway for use with an Asterisk server:
>
> Connect the gateway to a network switch and connect a computer to the same
> switch. Then configure the IP address of the computer to 10.1.10.2. Then run
> your web browser and point it to http://10.1.10.10 and login using the
> information below.
>
> Default IP address: 10.1.10.10
> Default user name: Admin
> Default password: Admin
>
> Goto "Quick Setup" and change the following:
> IP Address => Set to the new IP address of the AudioCodes gateway
> Subnet Mask => Set to the correct netmask for your local network
> Default Gateway Address => Set to the correct gateway IP address for your
> local network
> Working With Proxy => Set to "Yes"
> Proxy IP Address => Set to the IP address of the Asterisk server
> Enable Registration => Set to "Enable"
>
> Restart the gateway then log back in using the new IP address.
>
> Goto Protocol Management -> Protocol Definition -> Proxy & Registration
> Registrar IP Address => Set to the IP address of the Asterisk server
> Registration Time => Set to "60"
> Subscription Mode => Set to "Per Endpoint"
> Authentication Mode => Set to "Per Endpoint"
>
> Goto Protocol Management -> Protocol Definition -> DTMF & Dialing
> Max Digits In Phone Num => Set to a large enough number such as "32"
>
> Goto Protocol Management -> Protocol Definition -> Coders
> Add coders as needed You need to set at least G.711U-law
>
> Goto Protocol Management -> Endpoint Settings -> Authentication
> Set SIP username and password for each port
>
> Goto Protocol Management -> Endpoint Phone Numbers
> Enter an extension (phone) number for every used channel
>
> Your AudioCodes gateway is now ready.
>
> Michael Crown
> Managing Partner
> www.thevoipconnection.com
> 321.989.6728 ext. 611
> sip:611 at voiceserver.thevoipconnection.com
>
>> -----Original Message-----
>> From: billy at kersting.com [mailto:billy at kersting.com]
>> Sent: Wednesday, May 24, 2006 10:23 PM
>> To: asterisk-biz at thevoipconnection.com
>> Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
>>
>> FXS
>>
>> -----Original Message-----
>> From: asterisk-users-bounces at lists.digium.com
>> [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of
>> The VoIP Connection
>> Sent: Wednesday, May 24, 2006 9:25 PM
>> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
>> Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
>>
>> FXS or FXO?
>>
>> Michael Crown
>> Managing Partner
>> www.thevoipconnection.com
>> 321.989.6728 ext. 611
>> sip:611 at voiceserver.thevoipconnection.com
>>
>>
>>> -----Original Message-----
>>> From: William Piper [mailto:billy at kersting.com]
>>> Sent: Wednesday, May 24, 2006 6:27 PM
>>> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
>>> Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
>>>
>>> Sorry to hijack your thread.
>>>
>>> Reading these posts made me grab my old MP-104 & try again
>> to get it
>>> working with asterisk. I bought it a while ago off eBay &
>> never could
>>> get it to register.
>>>
>>> Does anyone have an example ini file for the MP-1XX that I
>> could look
>>> at & figure out what I am configuring wrong on this box?
>>>
>>> Thanks,
>>>
>>> bp
>>>
>>> -----Original Message-----
>>> From: asterisk-users-bounces at lists.digium.com
>>> [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jerry
>>> Jones
>>> Sent: Wednesday, May 24, 2006 6:04 PM
>>> To: Asterisk Users Mailing List - Non-Commercial Discussion
>>> Subject: Re: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
>>>
>>> From my copy of the manual
>>>
>>>
>>> MP-1xx SIP User's Manual 36 Document #: LTRT-65404 You can use the
>>> 'Reset' button to restore the MP-1xx networking parameters to their
>>> factory default values (described in Table 4-1) and to reset the
>>> username and password.
>>> Note that the MP-1xx returns to the software version burned
>> in flash.
>>> This process also restores
>>> the MP-1xx parameters to their factory settings, therefore you must
>>> load your previously backed- up ini file, or the default ini file
>>> (received with the software kit) to set them to their
>> correct values.
>>> To restore networking parameters to their initial state,
>> take these 6
>>> steps:
>>> 1. Disconnect the MP-1xx from the power and network cables.
>>> MP-1xx SIP User's Manual 4. Getting Started 2. Reconnect the power
>>> cable; the gateway is powered up. After approximately
>>> 45 seconds the Ready LED turns to green and the Control LED
>> blinks for
>>> about 3 seconds.
>>> 3. While the Control LED is blinking, press shortly on the reset
>>> button (located on the left side of the front panel); the gateway
>>> resets a second time and is restored with factory default
>> parameters
>>> (username: "Admin", password: "Admin").
>>> 4. Reconnect the network cable.
>>> 5. Assigning the MP-1xx IP address (refer to Section 4.1
>> on page 35).
>>> 6. Load your previously backed-up ini file, or the default ini file
>>> (received with the software kit).
>>> To load the ini file via the Embedded Web Server, refer to
>> Section
>>> 5.9.2.1 on page 120.
>>>
>>>
>>>
>>>
>>> On May 24, 2006, at 3:00 PM, Erick Perez wrote:
>>>
>>>> Just a question, has anyone knows how to blank or factory
>> reset an
>>>> AudioCodes MP124-C/FSX/AC/SIP unit (it's a 24 FSX to SIP unit).
>>>> I purchased them second-handed with no manuals (thank god for the
>>>> internet!!) but i guess the pdf manual I have does not have the
>>>> section of factory-reset.
>>>>
>>>> Also, any sucess stories with:
>>>> AudioCodes MP124-C/FSX/AC/SIP
>>> <--->Asterisk<---internet<--->Vonage
>>>> setups?
>>>>
>>>> Thanks,
>>>>
>>>>
>>>> --
>>>>
>>>> -------------------------------------------
>>>> Erick Perez
>>>> Linux User 376588
>>>> http://counter.li.org/ (Get counted!!!) Panama, Republic
>> of Panama
>>>> _______________________________________________
>>>
>>>
>>>
>>>
>>
>> _______________________________________________
>> --Bandwidth and Colocation provided by Easynews.com --
>>
>> Asterisk-Users mailing list
>> To UNSUBSCRIBE or update options visit:
>> http://lists.digium.com/mailman/listinfo/asterisk-users
>>
>>
>> __________ NOD32 1.1556 (20060525) Information __________
>>
>> This message was checked by NOD32 antivirus system.
>> http://www.eset.com
>>
>>
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-biz mailing list
> To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-biz
>
More information about the asterisk-biz
mailing list