Hi,<br><br>I'm facing an issue with which loading wctdm24xxp module fails.<br><br>Here is relevant dmesg's output :<br><br>[ 13.455729] dahdi: Telephony Interface Registered on major 196<br>[ 13.455729] dahdi: Version: 2.4.0<br>
[ 13.510847] ACPI: PCI Interrupt 0000:01:0b.0[A] -> GSI 22 (level, low) -> IRQ 22<br>
[ 15.527788] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 17.527787] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 19.527787] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>
[ 21.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 23.527784] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 25.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>
[ 27.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 29.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[ 31.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>
[ 33.527942] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.<br>[
33.527995] wctdm24xxp 0000:01:0b.0: The firmware may be corrupted.
Please completely power off your system, power on, and then reload th<br>
e driver with the 'forceload' module parameter set to 1 to attempt recovery.<br>[ 33.544741] ACPI: PCI interrupt for device 0000:01:0b.0 disabled<br>[ 33.544757] wctdm24xxp: probe of 0000:01:0b.0 failed with error -5<br>
[ 34.157817] dahdi: Registered tone zone 2 (France)<br>[ 38.873158] warning: `ntpd' uses 32-bit capabilities (legacy support in use)<br>[ 47.462040] dahdi: Detected time shift.<br><br>My setup is :<br>
Asterisk box with HA8+B400M <---ISDN/BRI----> Patton SN4638 <----SIP---> Asterisk<br><br>Patton SN4638 is configured to behave as telco node (ie NT/PtmP).<br><br><br>To narrow my research scope, I'm wondering if the followin sentence is true :<br>
"if you load a dahdi module with a modprobe command (like modprobe wctdm24xxp) disconnect any cable of any kind connected to the corresponding PCI board, should this command succeed or fail"<br><br>In other words, do you need to connect board to a public network when configuring it ?<br>
<br>Regards<br>