Hello,<br><br>In my system, dmesg outputs :<br><br>[ 13.039788] wcb4xxp 0000:01:0a.0: probe called for b4xx...<br>[ 13.039788] ACPI: PCI Interrupt 0000:01:0a.0[A] -> GSI 21 (level, low) -> IRQ 21<br>[ 13.039788] wcb4xxp 0000:01:0a.0: Identified HFC-8S Junghanns.NET octoBRI PCI (controller rev 1) at 0001dfe0, IRQ 21<br>
[ 13.041202] wcb4xxp 0000:01:0a.0: NOTE: hardware echo cancellation has been disabled<br>[ 13.041477] wcb4xxp 0000:01:0a.0: Port 1: TE mode<br>[ 13.041591] wcb4xxp 0000:01:0a.0: Port 2: NT mode<br>[ 13.044952] wcb4xxp 0000:01:0a.0: Port 3: TE mode<br>
[ 13.045116] wcb4xxp 0000:01:0a.0: Port 4: TE mode<br>[ 13.045116] wcb4xxp 0000:01:0a.0: Port 5: TE mode<br>[ 13.045116] wcb4xxp 0000:01:0a.0: Port 6: TE mode<br>[ 13.045116] wcb4xxp 0000:01:0a.0: Port 7: TE mode<br>
[ 13.045116] wcb4xxp 0000:01:0a.0: Port 8: TE mode<br>[ 13.045116] wcb4xxp 0000:01:0a.0: Did not do the highestorder stuff<br>[ 13.139884] wcb4xxp 0000:01:0a.0: new card sync source: port 3<br>[ 13.630304] wcb4xxp 0000:01:0a.0: Span 5 has invalid sync priority (5), removing from sync source list<br>
[ 13.630304] wcb4xxp 0000:01:0a.0: Span 6 has invalid sync priority (6), removing from sync source list<br>[ 13.630304] wcb4xxp 0000:01:0a.0: Span 7 has invalid sync priority (7), removing from sync source list<br>[ 13.630304] wcb4xxp 0000:01:0a.0: Span 8 has invalid sync priority (8), removing from sync source list<br>
[ 13.666827] dahdi_echocan_oslec: Registered echo canceler 'OSLEC'<br>[ 13.671632] dahdi: Registered tone zone 2 (France)<br>[ 13.730925] wcb4xxp 0000:01:0a.0: new card sync source: port 1<br><br><br>The strange thing is I'm quite certain the jumper for port 2 is set to TE mode (I checked twice).<br>
Could this come for a bug in wcb4xxp ?<br>The card is an old Junghanns OctoBRI.<br><br>Regards<br><br><br>