Hello users,<br><br>i have recently purchased Authentica x100p Fxo card for asterisk 1.4<br>i have following settings<br><br># /etc/zaptel.conf<br>fxsks=1<br>loadzone=in<br>defaultzone=in<br><br># /etc/asterisk/zapata.conf<br>
[channels]<br>context=from-pstn<br>usecallerid=no<br>hidecallerid=yes<br>immediate=no<br><br>signalling=fxs_ks<br>echocancel=yes<br>channel => 1<br><br>#/etc/asterisk/extensions.conf<br><br>[from-pstn]<br><br>exten => s,1,Answer()<br>
exten => s,n,Playback(vm-intro)<br>exten => s,n,Hangup()<br><br><br># lspci -vv<br><br> 11:00.0 Communication controller: Motorola Wildcard X100P<br> Subsystem: Efar Microsystems: Unknown device 0001<br>
Flags: bus master, medium devsel, latency 32, IRQ 193<br> I/O ports at 2000 [size=256]<br> Memory at ed100000 (32-bit, non-prefetchable) [size=4K]<br> Capabilities: [40] Power Management version 2<br>
<br># cat /proc/interrupts<br><br> CPU0 CPU1<br> 0: 921447 931323 IO-APIC-edge timer<br> 1: 5 5 IO-APIC-edge i8042<br> 8: 0 1 IO-APIC-edge rtc<br>
9: 0 0 IO-APIC-level acpi<br> 12: 34 33 IO-APIC-edge i8042<br> 14: 140339 90649 IO-APIC-edge ide0<br> 15: 0 0 IO-APIC-edge libata<br>169: 38 25 IO-APIC-level ehci_hcd, uhci_hcd, uhci_hcd<br>
177: 0 0 IO-APIC-level uhci_hcd, uhci_hcd<br>185: 9688 9482 IO-APIC-level libata, ehci_hcd, uhci_hcd, uhci_hcd<br>193: 116 36 IO-APIC-level wcfxo<br>209: 15304 0 PCI-MSI eth0<br>
NMI: 1 0<br>LOC: 1844122 1843838<br>ERR: 0<br>MIS: 0<br><br><br>#cat /proc/zaptel/1<br><br>Span 1: WCFXO/0 "Wildcard X100P Board 1" (MASTER)<br> 1 WCFXO/0/0 FXSKS (In use)<br>
<br><br><br><br>i am unable to make incoming calls route to the asterisk.<br>i didnt see anything in my asterisk CLI.<br><br><br><br>can anybody advise??<br><br>Thanks in advance<br clear="all">Srinivas Antarvedi<br><br>