<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<meta content="text/html;charset=ISO-8859-1" http-equiv="Content-Type">
</head>
<body bgcolor="#ffffff" text="#000000">
One thing to keep in mind is that the Grandstream's firmware is
notoriously buggy and unreliable. I've got one GXP2000 here that is on
the 1.1.5.15 firmware, and I wouldn't even consider upgrading other
phones to them. Unfortunately, the quality of the Grandstream firmware
is appalling and doesn't seem to be getting any better - if anything,
the stability is getting <i>worse</i>.<br>
<br>
My advise for what it's worth is to use the Grandstream phones to their
best purpose - as a doorstop (albeit for a fairly light door)<br>
<br>
<br>
Peder @ NetworkOblivion wrote:
<blockquote cite="mid:47B1185B.70703@networkoblivion.com" type="cite">
<pre wrap="">I hate to reply to my own message, but I have some more info from
debugging. A Grandstream tries to register and uses a nonce and it is
accepted by *. The next time it tries to register, it uses the same
none and * says "SIP/2.0 401 Unauthorized". The Grandtream says "ok,
here try this new nonce" and then it works again. Again, the next time
it registers, it tries the old one and gets slapped again and gives a
new one. After some indeterminate amount of time, the Grandstream
actually tries to use the same nonce 3 times in a row. Once it works,
the next time it gets a "SIP/2.0 401 Unauthorized" and then the third
time, it gets a "SIP/2.0 403 Forbidden". This evidently causes the
Grandstream to completely give up registration as once * sends this, the
Grandstream nevers tries to register again. I've waited for 1-2 hours
and it never tries again. The "Forbidden" response appears to kill
registration until the Grandstream is rebooted. Has anybody else seen
this? Or maybe know how to get around it?
Peder @ NetworkOblivion wrote:
</pre>
<blockquote type="cite">
<pre wrap="">I did post most of that. Point to point T1, no firewalls and no nat,
cisco routers, bandwidth is monitored at 30 second intervals and never
exceeds 50%, almost always 25% or less. The key is that I get messages
from * like "failed to register" and it is from the IP of the phone, so
it is like the phone is sending some messed up message. Asterisk is
old, 1.0.3, but it has been stable for 2-3 years with zero issues.
While it could be a asterisk version issue, I have 100-150 phones on it,
mostly Cisco 7940/7960 and none of them have these issues. The only
phones with issues appear to be Grandstream and they are all running
1.1.5.15. Here is a sample sip config:
[7834-1]
context=HASKI-LD
type=friend
callerid="HASKI" <7834>
username=7834-1
secret=47834-1
host=dynamic
mailbox=7834@HASKI-VM
canreinvite=no
qualify=yes
Here is one of the log messages:
Feb 11 18:18:05 NOTICE[20905]: Registration from
'<a class="moz-txt-link-rfc2396E" href="mailto:sip:7834-1@192.168.1.10"><sip:7834-1@192.168.1.10></a>' failed for '192.168.2.165'
That message is from a phone that is set to register every 5 minutes.
It's been 50 minutes and it still hasn't re-registered. If I reboot the
phone, it will register right away...
Any ideas?
Peder
Andrew Joakimsen wrote:
</pre>
<blockquote type="cite">
<pre wrap="">Yes but network issues are still possible. What sort of network
connections are you using? What sort of routers/firewalls/other
network gear? Are you certain of the reliability of the T1? Also you
did not post what Asterisk version is in use. Please also post the
relevant sip.conf and configuration file of the phone.
On Feb 11, 2008 4:52 PM, Peder @ NetworkOblivion
<a class="moz-txt-link-rfc2396E" href="mailto:peder@networkoblivion.com"><peder@networkoblivion.com></a> wrote:
</pre>
<blockquote type="cite">
<pre wrap="">I have 20-30 GXP2000's connected to * over a T1 line. Neither end is
NAT'd and there is plenty of bandwidth available over the line. The
GXP's are 1.1.5.15, which is the latest. I have a problem where the
phones keep dropping off of * and I get a "failed to register" message
in the log of *. Sometimes they eventually connect and sometimes, I
have to reboot them to get them to reconnect (I never change the config
though). Has anybody seen this? I've tried lowering the Register
Expiration and that seems to make it worse. If I lower it to 1 minute
or 5 minutes, I lose them every 10-15 minutes. If I put it at 10
minutes, it loses connectivity once or twice a day. I tried Grandstream
support and their answer was completely useless. Has anybody seen this?
Or does anybody have any ideas? Again, no NAT involved, so don't say
STUN or NAT issue.
Peder
_______________________________________________
-- Bandwidth and Colocation Provided by <a class="moz-txt-link-freetext" href="http://www.api-digital.com">http://www.api-digital.com</a> --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
<a class="moz-txt-link-freetext" href="http://lists.digium.com/mailman/listinfo/asterisk-users">http://lists.digium.com/mailman/listinfo/asterisk-users</a>
</pre>
</blockquote>
<pre wrap="">_______________________________________________
-- Bandwidth and Colocation Provided by <a class="moz-txt-link-freetext" href="http://www.api-digital.com">http://www.api-digital.com</a> --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
<a class="moz-txt-link-freetext" href="http://lists.digium.com/mailman/listinfo/asterisk-users">http://lists.digium.com/mailman/listinfo/asterisk-users</a>
</pre>
</blockquote>
<pre wrap="">_______________________________________________
-- Bandwidth and Colocation Provided by <a class="moz-txt-link-freetext" href="http://www.api-digital.com">http://www.api-digital.com</a> --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
<a class="moz-txt-link-freetext" href="http://lists.digium.com/mailman/listinfo/asterisk-users">http://lists.digium.com/mailman/listinfo/asterisk-users</a>
</pre>
</blockquote>
<pre wrap=""><!---->
_______________________________________________
-- Bandwidth and Colocation Provided by <a class="moz-txt-link-freetext" href="http://www.api-digital.com">http://www.api-digital.com</a> --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
<a class="moz-txt-link-freetext" href="http://lists.digium.com/mailman/listinfo/asterisk-users">http://lists.digium.com/mailman/listinfo/asterisk-users</a>
</pre>
</blockquote>
</body>
</html>