<div>Hi everybody</div>
<div> </div>
<div>I hope that somebody can help me with the following ....</div>
<div> </div>
<div>I have</div>
<div> 2 quadbri cards</div>
<div>2 - 1t0 cards</div>
<div>1 pabx alcatel 4200</div>
<div> </div>
<div>I would like to connect my asterisk to the alcatel ,</div>
<div> </div>
<div>I installed bristuff 0.3.0-1p ,</div>
<div>loaded the zaphfc driver in NT mode</div>
<div>configured zaptel and zapata , it works great.</div>
<div> </div>
<div> </div>
<div>then I removed the 1 t0 card,</div>
<div>added the quadbri</div>
<div>loaded qozap : insmod qozap.ko ports=15 ( 4 ports in NT )</div>
<div> </div>
<div>adjusted the zaptel zapata, specified the right signalling, right context</div>
<div>ran ztcfg -vv ( 12 channels configured ) </div>
<div>started asterisk,</div>
<div>I get layer1 down message on the 4 ports,</div>
<div>leds remain red</div>
<div>what ever I do in my conf , I am not able to get a reaction from the card ( I tried with my two quadbri, on 2 different pc's ) </div>
<div> </div>
<div> </div>
<div>what can I check ?</div>
<div>thanks</div>
<div>jl</div>