Hello:<br><br>After configuring FXS and FXO channels of a TDM11B card, I can make calls from the telephone attached to the TDM11B card to the outsite (the PSTN, analog line), The problem is when I try to dial from the PSTN to my asterisk box (it has to make ring the handset on the TDM card), but I got infinite "Poopy (00) on card 4!"
<br><br><br>What is the problem?.<br><br><br>This is the output of the wctdm module loaded with debug=1<br><br><br>ACPI: PCI interrupt 0000:00:08.0[A] -> GSI 19 (level, low) -> IRQ 169<br>Freshmaker version: 73<br>Freshmaker passed register test
<br>ProSLIC on module 0, product 0, version 2<br>ProSLIC on module 0 seems sane.<br>ProSLIC on module 0 powered up to -75 volts (c9) in 8 ms<br>Loop current set to 20mA!<br>Post-leakage voltage: 33 volts<br>ProSLIC on module 0 powered up to -72 volts (c2) in 5 ms
<br>Loop current set to 20mA!<br>Calibration Vector Regs 98 - 107:<br>98: 11<br>99: 10<br>100: 0e<br>101: 0e<br>102: 00<br>103: 54<br>104: 05<br>105: 2a<br>106: 20<br>107: 08<br>Init Indirect Registers completed successfully.
<br>Proslic module 0 loop current is 20mA<br>Module 0: Installed -- AUTO FXS/DPO<br>ProSLIC on module 1, product 0, version 0<br>Module 1: Not installed<br>ProSLIC on module 2, product 0, version 0<br>Module 2: Not installed
<br>ProSLIC on module 3, product 0, version 0<br>VoiceDAA System: 04<br>ISO-Cap is now up, line side: 03 rev 03<br>Module 3: Installed -- AUTO FXO (FCC mode)<br>Found a Wildcard TDM: Wildcard TDM400P REV I (2 modules)<br>
10299583 Polarity reversed (0 -> -1)<br>wctdm: Card 0 Going off hook<br>wctdm: Card 0 Going on hook<br><br>and when receiving a call from the PSTN I see this on /var/log/messages<br><br><br>Mar 27 22:32:25 lineox kernel: Registered tone zone 2 (France)
<br>Mar 27 22:32:36 lineox kernel: RING on 1/4!<br>Mar 27 22:32:36 lineox kernel: Poopy (ffffffff) on card 4!<br>Mar 27 22:32:36 lineox kernel: Poopy (00) on card 4!<br>Mar 27 22:32:44 lineox last message repeated 527 times
<br><br><br>What should be the problem?. What am I doing wrong?.<br><br><br><br>my ztcfg -vvv says<br><br><br><br>Zaptel Configuration<br>======================<br><br><br>Channel map:<br><br>Channel 01: FXO Kewlstart (Default) (Slaves: 01)
<br>Channel 04: FXS Kewlstart (Default) (Slaves: 04)<br><br>2 channels configured.<br><br><br><br>Thanks a lot in advance for the help.<br><br><br><br>