Dear all.<br>
<br>
I am new using asterisk.<br>
I planned to have in my company an asterisk pbx that as a start would
be serving one analog phone, four sip hardphone extensions and two Iax
softphone. The next plan is to integrate asterisk with an old PBX
Alcatel 4100 and 3 lines to the public phone company.<br>
So I bought a very basic digium card (10B) with one FXS module as a start. <br>
I have been strugling for a month to get it going without success.<br>
Installation went fine, zaptel driver loads correctly. What I can hear
is a constant ring on the connected phone (is this normal?) and when I
pick it up, I hear a dialtone. Went into configuration of zapata.conf.
Everything seems to be correct as when I run asterisk in verbose mode,
it gives no errors (it connects). Lifing the headset, I can still
hear a tone but when it comes to dialing , nothing happens
(meaning I hear the DTMF with the dialtone). I have been
fighting with the extension.conf file and try to
understand the logic behind it. Read so many things on the net
(voip wiki) but seems to be very difficult since I did not find
any "dummies" explanation for it.<br clear="all">Can somebody help me configuring my basic asterisk pbx possible with an explanation on what the most important lines means?<br>
Can somebody help me build the configuration for further expansion of my pbx system?<br>
<br>
Regards.<br>-- <br>____________________________<br>Joao Carlos de Timóteo Mavimbe<br><br>