<DIV><BR><B><I>Peter Svensson <psvasterisk@psv.nu></I></B> wrote:</DIV>
<DIV>
<BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">
<P>On Sun, 19 Dec 2004, Jens Kübler wrote:<BR><BR>> I've bought the Wildcard TE110 some days ago but I'm unable to get it to work <BR>> with Siemens HiCom 300.<BR>> <BR>> I've tried this so far:<BR>> 1. I've used standard cat5 cable cut off on one edge and twisted wires 1 to 4 <BR>> and 2 to 3 which is according to cisco a short circuit for E1 lines. Wildcard <BR>> takes a few seconds and sets the link to green (OK).<BR><BR>It should be 1 to 4 and 2 to 5, not 3. The pairs are 1-2 and 4-5.<BR></P>
<P>Hi,</P>
<DIV>Using a DIUS2 on the Hicom, you have to loop 3-10 and 7-14. .</DIV>
<DIV>Using a DIUN2 on the Hicom, the loop is not necessary.</DIV>
<DIV> </DIV>
<DIV>BTW 1-9 is Tx and 7-14 is RX.</DIV>
<DIV> </DIV>
<DIV>hope it will help.</DIV>
<P><BR>> 2. I've tried to connect our running E1 line from the telco with wildcard. The <BR>> modem (modulates HDSL to G703 120 Ohms). I've used a 1:1 cable that did not <BR>> work. I even tried to connect the copper wires by hand which resulted that <BR>> the modem gave me a green power light but Wildcard stayed on a waving red <BR>> light.<BR><BR>That should have worked, as long as 1-1, 2-2, 4-4 and 5-5. Are you sure <BR>the signalling is correct? What did zttool say?<BR><BR>> 3. I have plugged out our running PBX and connected it to Wildcard which <BR>> resulted in a green light for one second and then the state from zttool <BR>> switched to yellow (and Wildcard to constant red light).<BR><BR>Yellow alert is remote alert, right? That would indicate that the path <BR>from the pbx to asterisk is ok, but not the path from asterisk to the pbx.<BR><BR>> The protocol used by the modem is hdb3 and /etc/zaptel.conf is adjusted <BR>> according to
this.<BR><BR>Do you have crc4 enabled? Care to post your zaptel.conf.<BR><BR>I think you have to start asterisk on the span to get the upper layers <BR>enabled.<BR><BR>Peter<BR><BR><BR>_______________________________________________<BR>Asterisk-Users mailing list<BR>Asterisk-Users@lists.digium.com<BR>http://lists.digium.com/mailman/listinfo/asterisk-users<BR>To UNSUBSCRIBE or update options visit:<BR>http://lists.digium.com/mailman/listinfo/asterisk-users<BR></P></BLOCKQUOTE></DIV><p>
<hr size=1>Do you Yahoo!?<br>
Read only the mail you want - <a href="http://us.rd.yahoo.com/mail_us/taglines/spamguard/*http://promotions.yahoo.com/new_mail/static/protection.html">Yahoo! Mail SpamGuard</a>.