[asterisk-users] Detected alarm on channel 3: Red Alarm

[Ryan, Travis]

> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-
> bounces at lists.digium.com] On Behalf Of Vitor Mazuco
> Sent: Tuesday, January 05, 2016 9:42 AM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [asterisk-users] Detected alarm on channel 3: Red Alarm
> 
> Humm, if I put a filter in this lines, maybe back?
> 
> 
> 
> 2016-01-05 12:36 GMT-02:00, Ryan, Travis <RyanT at oscarwinski.com>:
> >
> >> -----Original Message-----
> >> From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-
> users-
> >> bounces at lists.digium.com] On Behalf Of Vitor Mazuco
> >> Sent: Tuesday, January 05, 2016 9:21 AM
> >> To: Asterisk Users Mailing List - Non-Commercial Discussion
> >> Subject: [asterisk-users] Detected alarm on channel 3: Red Alarm
> >>
> >> Hi everyone!
> >>
> >> I have a Digium Card TDM410
> >>
> >> But, it appear for me this massege
> >>
> >> chan_dahdi.c:8061 handle_alarms: Detected alarm on channel 3: Red
> >> Alarm
> >>
> >> But my line is ok!
> >>
> >> But sometimes it back
> >>
> >> sig_analog.c:3807 analog_handle_init_event: Alarm cleared on channel
> >> 2
> >>
> >> But it again back to red alarm.
> >>
> >> What can be happen?
> >>
> >> My lines is all ok! But when I put on Digium Card TDM410 is very
> >> inconsistent
> >>
> >> Thanks
> >>
> >> --
> > Honestly, I've only had red alarms on any of my cards if there was a
> > problem with the lines or service over those lines. Maybe someone
> else
> > could speak to other reasons the red light might appear.
> >
> >
> > --

[Ryan, Travis] Is your line pretty long? Maybe the distance is far so the signal is weak?