[asterisk-users] PRI timing settings

[Don Kelly]

Doubtful that T309 or T316 are causing the problem, but you can always change them to correspond with their defaults.

 

http://www.nmscommunications.com/manuals/6272-16/appendxe.htm

 

  --Don

 

 

From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jeff LaCoursiere
Sent: Tuesday, August 19, 2014 4:56 PM
To: asterisk-users at lists.digium.com >> Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] PRI timing settings

 

Hello,

I wrote earlier today about a new PRI installation in the Caribbean, where all outbound calls are functioning fine *except* calls to Sprint phone numbers, which get rejected immediately as "busy".

The telco has been working with their switch manufacturer and took the output of "pri show span 1" from me and came back with this:

----quote---

Please check your timers below.  How did you determine your settings?

*	Timer and counter settings:
  N200: 3
  N202: 3
  K: 7
  T200: 1000
  T201: 1000
  T202: 2000
  T203: 10000
  T303: 4000
  T305: 30000
  T308: 4000
  T309: 6000    Our switch: Telcordia National ISDN 2: Range 10 - 90 seconds, default 90 seconds. 

*	
  T312: 6000
  T313: 4000
  T316: -1        Our switch: Telcordia National ISDN 2: Range 10 - 120 seconds, default 30 seconds. 


  N316: 2
  T-HOLD: 4000
  T-RETRIEVE: 4000
  T-RESPONSE: 4000

---end quote---


Now I have no idea what T309 or T316 represent, but it seems odd that timers and counters would cause such an odd result... and the failure is immediate, not after some amount of timeout.  Can anyone shed light on these settings and tell me if they are configurable?

Cheers,

j

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.digium.com/pipermail/asterisk-users/attachments/20140819/8c69316d/attachment.html>