[asterisk-users] Way to dump PRI settings?

[Jeff LaCoursiere]

Perfect!  Exactly what I was looking for.

Cheers,

j

On 08/19/2014 12:23 PM, Eric Wieling wrote:
> I doubt PBX settings (other than CallerID) would break calling to only one specific carrier.
>
> Have you tried pri show span X?
>
>  From one of our boxes:
>
> pbx*CLI> pri show span 1
> Primary D-channel: 24
> Status: Up, Active
> Switchtype: National ISDN
> Type: CPE
> Remote type: Unknown node type
> Overlap Dial: 0
> Logical Channel Mapping: 0
> Timer and counter settings:
>    N200: 3
>    N202: 3
>    K: 7
>    T200: 1000
>    T201: 1000
>    T202: 10000
>    T203: 10000
>    T303: 4000
>    T305: 30000
>    T308: 4000
>    T309: 6000
>    T312: 6000
>    T313: 4000
>    T316: -1
>    N316: 2
>    T-HOLD: 4000
>    T-RETRIEVE: 4000
>    T-RESPONSE: 4000
> Q931 RX: 6350
> Q931 TX: 5828
> Q921 RX: 42786
> Q921 TX: 42716
> Q921 Outstanding: 0 (TEI=0)
> Total active-calls:2 global:1
> CC records:
> Overlap Recv: No
>
> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jeff LaCoursiere
> Sent: Tuesday, August 19, 2014 5:00 PM
> To: asterisk-users at lists.digium.com >> Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: [asterisk-users] Way to dump PRI settings?
>
> Hello,
>
> I am having odd issues with a new PRI based installation.  Outbound
> calls work for all numbers except those that terminate at Sprint! The
> telco is new to PRI (this is in the Caribbean) and say that Sprint is
> rejecting the calls, and asked for our PRI settings so they can work
> with their switch manufacturer.  We are using the bare minimum default
> settings, but I can imagine that a whole ton of configurable settings
> exist that I have never played with.
>
> Is there a way to dump all of the configurable settings for a PRI? The
> card is a Digium TE122.
>
> Thanks,
>
> j
>