[asterisk-users] BRI Installation

[Kevin P. Fleming]

On 06/05/2012 12:39 AM, Klaverstyn, David C wrote:
> Hi Guys,
>
> All my installs are based on PRI ISDN. I now have a site that I need to
> install BRI. As I have not done a BRI install before I’m wanting to get
> some information from the people in the know if I need to do anything
> special.
>
> Typically I install libpri, dahdi Linux and tools, asterisk
>
> ...and then configure dahdi as one does for the required hardware. Is
> the same true for BRI with the exception of the libpri? I have this
> feeling that I need to install some other Linux drivers or something for
> BRI.
>
> I’ve purchased a Digium HB8 card and I don’t see any mention of this in
> /etc/dahdi/modules. I’ve looked over the documentation at
> https://www.digium.com/en/supportcenter/documentation/viewdocs/H8 but
> there doesn’t seem to be anything there that tells me how to configure
> dahdi or asterisk.
>
> If someone could give me some direction that would be greatly appreciated.

The Hx8 User's Manual (here: 
http://docs.digium.com/H8/hx8_series_manual.pdf) has an entire chapter 
on software installation and configuration, including DAHDI, libpri and 
Asterisk.

-- 
Kevin P. Fleming
Digium, Inc. | Director of Software Technologies
Jabber: kfleming at digium.com | SIP: kpfleming at digium.com | Skype: kpfleming
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at www.digium.com & www.asterisk.org