[asterisk-users] chan_capi audio weirdness

[Arik Raffael Funke]

Hi Armin,

On 18/02/2012 19:28, Arik Raffael Funke wrote:
>> in NT mode, the B-channel is not activated automatically. You have to
>> signal
>> the TE side that early-B3 data is available. Then the TE side can
>> activate
>> the B-channel. If the NT-side is chan_capi, use
>> exten => _X.,n,capicommand(progress)
 >
> I tried what you suggested - but without any luck. To make sure I did
> not misunderstand you, I now have:
> exten => _X.,1,capicommand(progress)
> exten => _X.,n,Dial(CAPI/capi_intern/12345/b)

To help identification of the problem, my console prints the following 
after capicommand(progress):

[Feb 19 10:45:08] WARNING[3483]: chan_capi.c:4972 show_capi_conf_error: 
ISDN_INTERN#02: conf_error 0x2001 PLCI=0x103 
Command=SELECT_B_PROTOCOL_CONF,0x8495
        > ISDN_INTERN#02: CAPI INFO 0x2001: Message not supported in 
current state

Regards,
Arik