[asterisk-users] wct4xxp Interrupts not detected with dahdi 2.6, but working ok with 2.5

[ebusic]

I have the same problem with OpenVOX D210E card

These one is not working:

dahdi: Telephony Interface Registered on major 196
dahdi: Version: 2.6.1
ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 16 (level, low) -> IRQ 169
wct4xxp 0000:03:00.0: Firmware Version: c01a0000
wct4xxp 0000:03:00.0: FALC Framer Version: Unknown (VSTR = 0x04)
wct4xxp 0000:03:00.0: Found a Wildcard: Wildcard TE210P 
wct4xxp 0000:03:00.0: VPM450: Not Present
dahdi_echocan_mg2: Registered echo canceler 'MG2'
wct4xxp 0000:03:00.0: TE2XXP: Span 1 configured for CCS/HDB3/CRC4
wct4xxp 0000:03:00.0: Lost crc4-multiframe alignment
wct4xxp 0000:03:00.0: SPAN 1: Primary Sync Source
wct4xxp 0000:03:00.0: RCLK source set to span 1
wct4xxp 0000:03:00.0: Recovered timing mode, RCLK set to span 1
wct4xxp 0000:03:00.0: TE2XXP: Span 2 configured for CCS/HDB3/CRC4
wct4xxp 0000:03:00.0: Lost crc4-multiframe alignment
wct4xxp 0000:03:00.0: SPAN 2: Secondary Sync Source
wct4xxp 0000:03:00.0: RCLK source set to span 1
wct4xxp 0000:03:00.0: Recovered timing mode, RCLK set to span 1


and these one working fine:

dahdi: Telephony Interface Registered on major 196
dahdi: Version: 2.5.0.2
ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 16 (level, low) -> IRQ 169
wct4xxp 0000:03:00.0: Found TE2XXP at base address e9100000, remapped to
ffffc20000066000
wct4xxp 0000:03:00.0: Firmware Version: c01a0000
wct4xxp 0000:03:00.0: Burst Mode: On
wct4xxp 0000:03:00.0: FALC Framer Version: 2.1 or earlier
wct4xxp 0000:03:00.0: Board ID: 00
wct4xxp 0000:03:00.0: Reg 0: 0x37ffc400
wct4xxp 0000:03:00.0: Reg 1: 0x37ffc000
wct4xxp 0000:03:00.0: Reg 2: 0xe9100008
wct4xxp 0000:03:00.0: Reg 3: 0x00000000
wct4xxp 0000:03:00.0: Reg 4: 0x00000000
wct4xxp 0000:03:00.0: Reg 5: 0xe9100014
wct4xxp 0000:03:00.0: Reg 6: 0xc01a0000
wct4xxp 0000:03:00.0: Reg 7: 0x00001f00
wct4xxp 0000:03:00.0: Reg 8: 0x00000000
wct4xxp 0000:03:00.0: Reg 9: 0x00000000
wct4xxp 0000:03:00.0: Reg 10: 0xe9100028
wct4xxp 0000:03:00.0: Found a Wildcard: Wildcard TE210P 
wct4xxp 0000:03:00.0: VPM450: Not Present
wct4xxp 0000:03:00.0: TE2XXP: Launching card: 0
dahdi_echocan_mg2: Registered echo canceler 'MG2'
wct4xxp 0000:03:00.0: TE2XXP: Span 1 configured for CCS/HDB3/CRC4
wct4xxp 0000:03:00.0: SPAN 1: Primary Sync Source
wct4xxp 0000:03:00.0: TE2XXP: Span 2 configured for CCS/HDB3/CRC4
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0081
wct4xxp 0000:03:00.0: RCLK source set to span 1
wct4xxp 0000:03:00.0: Recovered timing mode, RCLK set to span 1
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0082
wct4xxp 0000:03:00.0: SPAN 2: Secondary Sync Source
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0082
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0082
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0081
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0081
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000001, CIS = 0082
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014
wct4xxp 0000:03:00.0: 2G: Got interrupt, status = 00000002, CIS = 0080
wct4xxp 0000:03:00.0: Reg 5 is e9100014

Can you fix that?

Thanks in advanced.