[asterisk-users] Asterisk + Patton ISDN2e gateway (UK)

[Gordon Henderson]

I know I asked this some time back, and I got no response then, and 
neither did someone who asked at the start of 2009 either by the looks of 
it (other than a reply from me to use a PCI card!!!)

However I now have a client who'd bought one of these boxes and installed 
ISDN2e - against my advice (because I got no feedback here, therefore 
they're junk with asterisk, right?)

However I'm currently stuck with it and it's a right royal PITA to program 
up by the look of it - I've done all the obvious stuff, and am now wading 
through their 600+page manual, but ugh...

So if anyone has used one with asterisk as a bridge to ISDN2e in the UK, 
would you mind sharing a config with me?

I have it registering (it pretends to be a SIP phone, it registers with 
Asterisk), but when I try to send a call to it, it times out - I do see 
debug on it's console though - same when I send a call into it from the 
PSTN side - I see ISDN debug messages, but no SIP activity.

And I thought Mediatrix units were bad - but at least they are relatively 
easy to program...

Bah.

Any clues appreciated,

Thanks,

Gordon