[asterisk-users] IAX channel name incorrect - Found in 1.2 still happens in 1.6

[Steve Davies]

*Bump* No takers? Perhaps no-one else thinks this is a bug?

Regards,
Steve

On 7 February 2011 16:45, Steve Davies <davies147 at gmail.com> wrote:
> Hi,
>
> The following IAX config (slightly edited) causes an issue for me in
> version 1.6.2.16.1, where my CDR data is unreliable.
>
> [user1]
> type=friend
> auth=md5
> accountcode=user1
> notransfer=yes
> context=context1
> host=10.0.0.250
> username=user1
> secret=secret1
> disallow=all
> allow=alaw
>
> [user2]
> type=friend
> auth=md5
> accountcode=user2
> notransfer=yes
> context=context2
> host=dynamic
> deny=0.0.0.0/0.0.0.0
> permit=10.0.0.0/24
> username=user2
> secret=
> disallow=all
> allow=alaw
>
> If a call comes in from 10.0.0.250, using username "user2" and with no
> password, then it is correctly authenticated against the [user2]
> section.
>    Accountcode is set to user2
>    Context is set to context2
> and the call mostly proceeds correctly, BUT the source channel name is
> set to IAX2/user1-nnnn, which is then seen both in the dialplan debug
> output, and in the CDR. I would expect the channel name to reflect the
> section name that was used to authenticate the call ie.
> IAX2/user2-nnnn; I specifically put a password onto [user1] so there
> is no possibility that the call is authenticating there.
>
> Am I missing something? Or is this a bug?
>
> Thanks,
> Steve
>