[asterisk-users] 2 HB8 cards in one server - first one is not recognized, the second is

[Administrator TOOTAI]

Le 26/10/2010 14:49, Shaun Ruffell a écrit :
> On 10/26/2010 06:38 AM, Administrator TOOTAI wrote:
>    
>> I installed 2 HB8 cards each of them with a Quad Bri modules in a HP 360
>> G6 running Debian Squeeze. Here is an output of dmesg wafter server has
>> booted:
>> [...]
>>      
>> before asking RMA for the card, I would like to know what you think
>> about this matter.
>>
>>      
> First, Digium technical support would be more than happy I'm sure to
> help you trouble shoot this. That being said...
>
> First thing I would do is update to the current trunk of dahdi-linux.
> Revision 9397 [1]
> http://svn.asterisk.org/view/dahdi?view=revision&revision=9397 was added
> because of some systems that did not provide reliable polling from the
> board side, which could result in erroneous "your firmware may be
> corrupted..." messages.  However, since you have one card that works and
> one that doesn't I give this a low probability of fixing it.
>    
Didn't test this yet but
> Next, if updating the driver does not help and if the problem follows
> the card (i.e., you can swap cards and now the second card fails to
> load),
switching cards gives kernel panic :-( on boot
>   I would disable dahdi from starting automatically, power off your
> system, remove the working card, power on, and try "modprobe wctdm24xxp
> forceload=1" on the chance that the firmware on the board actually is
> corrupted.
>    
Will try card by card, then slot per slot

Thanks for your help
-- 
Daniel