[asterisk-users] "Contact header appears incorrect on this invite" Asterisk registering with another PBX

[Gareth Blades]

Mike A. Leonetti wrote:
> On 05/07/10 12:14, Gareth Blades wrote:
>> Mike A. Leonetti wrote:
>>   
>>> On 05/07/10 11:52, Gareth Blades wrote:
>>>     
>>>> Mike A. Leonetti wrote:
>>>>   
>>>>       
>>>>> In an attempt to connect our Asterisk 1.6 phone system with another 
>>>>> phone system called "Broadsmart", they gave me credentials to register to.
>>>>>
>>>>> Connected to Asterisk 1.6.2.5 currently running on watermelon (pid = 10365)
>>>>> watermelon*CLI> sip show registry
>>>>> Host                           dnsmgr Username       Refresh 
>>>>> State                Reg.Time
>>>>> {broadsmart_ip}:5060              N      {broadsmart_user}        3317 
>>>>> Registered           Fri, 07 May 2010 11:21:41
>>>>> 1 SIP registrations.
>>>>>
>>>>> It shows that I am registered.  But when I go to make a call using:
>>>>> exten => 706,1,Macro(broadsmart,706)
>>>>>
>>>>> and the Macro
>>>>> [macro-broadsmart]
>>>>> exten => s,1,Dial(SIP/${arg1}@broadsmart,60)
>>>>>
>>>>> Asterisk reports:
>>>>> [May  7 11:34:45] WARNING[10402]: chan_sip.c:17775 
>>>>> handle_response_invite: Received response: "Forbidden" from '"Mike A. 
>>>>> Leonetti" <sip:{broadsmart_user}@broadsmart.net>;tag=as6376d669'
>>>>>
>>>>> The people on the other end sent me this e-mail:
>>>>>     
>>>>>         
>>>> The register command has one set of credentials but if you are dialing 
>>>> using Dial(SIP/${arg1}@broadsmart,60) then the credentials will be 
>>>> looked up in the [broadsmart] section within sip.conf
>>>>
>>>>   
>>>>       
>>> So is there a way to dial out using what is already registered?
>>>
>>>     
>> No. The server you register with can often be different to the one you 
>> pass calls to so keeping them completely separate makes a lot of sense.
>> You can put the authentication information in the dial command itself 
>> but that is generally not a good idea because it can expose the username 
>> and password to other applications which integrate into asterisk or when 
>> viewing the asterisk console.
>>
>>
>>   
> So then where is my mistake?  The credentials in broadsmart look like
> the same from whats being registered.
> 
I cant say but just made you aware that both are separate so the 
password may be wrong in one place. It would be best to do a sip debug 
and that may help diagnose the problem.

I am off now so wont be back until after the weekend so hopefully 
someone else will help furthur.