[asterisk-users] FIXED: DAHDI: Inbound BRI call, DDI not presented

[Scott Stingel]

Thanks to the OpenVox engineer for picking this up:

I had "bri_cpe" for my signaling type, should be "bri_cpe_ptmp".  The 
BRI circuit on the B200P works fine now in both directions.

-Scott


On 6/22/2010 7:58 AM, Scott Stingel wrote:
>
> On 6/22/2010 2:03 AM, Tzafrir Cohen wrote:
>    
>> On Mon, Jun 21, 2010 at 09:08:02AM -0700, Scott Stingel wrote:
>>
>>      
>>> Hello-
>>>
>>> I have a system with one D410P and one B200P (both OpenVox).  All is
>>> well with the D410P, inbound and outbound, and I can initiate calls on
>>> the B200P  BRI span, but there may be something wrong with my inbound
>>> BRI setup:  there is no indication of an inbound call when I dial in to
>>> it from the PSTN.
>>>
>>> When I run "pri intense debug" and make a call to the BRI span, I can
>>> see a message containing the DDI that I'm dialing, in this case 336027
>>> (BT supplies only the last 6 digits of a delivered number).  See debug
>>> output below...
>>>
>>>        
>>