[asterisk-users] Problem with GROUP()

[Andres]

On 6/5/2010 11:37 AM, Jonas Kellens wrote:
> I made your adjustments, but still the same result .
>
> dialplan :
>
> exten => s,n,Set(GROUP()=${custID})
> exten => s,n,NoOp(This channel is member of group: ${GROUP()})
> exten => s,n,GROUP()
GROUP is not an application. You cannot call it like that.  Try to 
follow the logic in the below example.  If the count is less that 4 it 
will jump to priority 5 and do whatever you want.  If the count is 4 or 
more it goes to busy.

exten => _01XXXXXXXXXX,1,Set(GROUP()=trunk1)
exten => _01XXXXXXXXXX,2,NoOP(Group Count = ${GROUP_COUNT(trunk1)} for 
Group = trunk1)
exten => _01XXXXXXXXXX,3,GotoIF($[${GROUP_COUNT(trunk1)} < 4]?5)
exten => _01XXXXXXXXXX,4,Busy(1)

Andres
http://www.neuroredes.com
> exten => s,n,NoOp(groepcount = GROUP_COUNT(${custID}))
>
> The CLI shows :
>
> [Jun  5 16:50:04]     -- Executing [s at sub-settings:5] 
> Set("IAX2/testlocal-128", "GROUP()=40") in new stack
> [Jun  5 16:50:04]     -- Executing [s at sub-settings:6] 
> NoOp("IAX2/testlocal-128", "This channel is member of group: 40") in 
> new stack
> [Jun  5 16:50:04] WARNING[10555]: pbx.c:1849 pbx_extension_helper: No 
> application 'GROUP' for extension (sub-settings, s, 7)
> [Jun  5 16:50:04]   == Spawn extension (sub-settings, s, 7) exited 
> non-zero on 'IAX2/testlocal-128'
> [Jun  5 16:50:04]     -- Hungup 'IAX2/testlocal-128'
>
>
> With GROUP() I want to increase the number of calls for this 
> "channel". How do I increase the number of GROUP() ??
>
>
> Jonas.
>
>
> On 06/05/2010 05:11 PM, Andres wrote:
>> Yes, you should do something like:
>>
>> exten =>  s,n,Set(GROUP()=${custID})
>>
>> GROUP in itself is not an application.  Thats why you are getting "No
>> application 'GROUP' for extension".
>>
>>
>>
>> Andres
>> http://www.neuroredes.com