[asterisk-users] no sound between extensions

[Gary Baribault]

This is done while the calls are active? I just issued the command and
got nothing, but there where no active calls.

Gary Baribault

On 06/01/2010 03:45 PM, Danny Nicholas wrote:
> My assumption is that inbound/outbound calls are DAHDI and that internal
> calls are SIP.  Can OP post "core show channels" from working and
> non-working calls?
>
> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com
> [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Gary Baribault
> Sent: Tuesday, June 01, 2010 2:20 PM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: [asterisk-users] no sound between extensions
>
> Hello all,
>
>    I have Asterisk 1.4.26 installed on an OpenSuSE 11.2 server with a
> Digium 8 port FXO card. The local network is 100Mbps Ethernet and my
> phones are Linksys SPA-921 or Linksys Analog adaptors.
>
>    The phones are setup with DHCP, and are on the same flat non-routed
> network. There is no NAT involved.
>
>    If I call from extension 6000 to extension 6001, or vice-versa both
> are SPA-921s. The 6001 rings, but when the phone is picked up, I have
> no sound. I have the same problem between any phones in the system,
> but this is the simplest example.
>
>    Incoming calls and outgoing calls work fine, sound is correct.
> Voice mail works fine as well, the IVR works great.
>
>    Any ideas?
>
> Gary Baribault
>
>
>
>