[asterisk-users] pri CLI command not available

[John Novack]

In the "good old days" ( ZAPTEL ) Channel => had to be the last line in 
a section. Everything after channel => was ignored.

Seems that has not changed.

A hard learned lesson by many !


Eric Merkel (Mail Lists) wrote:
>
> Thanks you were exactly right. I had a problem in my chan_dadhi.conf 
> file. Basically, I had the channels defined before the signaling and 
> it wouldn’t load. It did not show any errors that I could see on 
> startup and there were no messages in the /var/log/asterisk/messages 
> but when doing a “load chan_dahdi.so” from the command line showed me 
> the problem.
>
> Thanks again!
>
> =====
>
> Eric Merkel
>
> ejmerkel.lists at gmail.com
>
> *From:* asterisk-users-bounces at lists.digium.com 
> [mailto:asterisk-users-bounces at lists.digium.com] *On Behalf Of 
> *Anthony Francis - Handy Networks LLC
> *Sent:* 2010-01-21 15:50
> *To:* Asterisk Users Mailing List - Non-Commercial Discussion
> *Subject:* Re: [asterisk-users] pri CLI command not available
>
> This is often caused by the dahdi module not loading, check 
> /var/log/asterisk/messages for the reason, or better yet, from the cli 
> load the module manually and see the error in real time. If I had to 
> guess I would say it is a configuration error.
>
> Thank you and have a nice day,
>
> Anthony Francis
>
> *From:* asterisk-users-bounces at lists.digium.com 
> [mailto:asterisk-users-bounces at lists.digium.com] *On Behalf Of *Eric 
> Merkel (Mail Lists)
> *Sent:* Thursday, January 21, 2010 1:41 PM
> *To:* asterisk-users at lists.digium.com
> *Subject:* [asterisk-users] pri CLI command not available
>
> I am in the process of trying to terminate a PRI into a new * server. 
> The server has an old T100P T1/PRI card in it. I have compiled the 
> following on Centos 5.4.
>
> dahdi-linux-complete-2.2.1+2.2.1
>
> libpri-1.4.10.2
>
> asterisk-1.4.29
>
> Everything seems to have compiled fine. DAHDI reports “Found a 
> Wildcard: Digium Wildcard T100P T1/PRI” on bootup. Dahdi_tool shows 
> that the span is up and active with no alarms however the phone 
> company is not seeing the trunkgroup going into service. I was wanting 
> to take a look at the PRI debugs but for some reason the CLI “pri” 
> option is not available. I libpri compiled without any issues prior to 
> compiling asterisk. What would cause the “pri debug” commands to not 
> be available in the CLI?
>
> =====
>
> Eric Merkel
>
> ejmerkel.lists at gmail.com
>
> ------------------------------------------------------------------------
>
>
>
> Checked by AVG - www.avg.com 
> Version: 9.0.730 / Virus Database: 271.1.1/2635 - Release Date: 01/20/10 14:18:00
>
>   

-- 
Dog is my co-pilot