[asterisk-users] B400P and A1200P changes card order

[Peter Gelencser]

2010.04.20. 16:50 keltezéssel, Shaun Ruffell írta:
> On 04/19/2010 03:48 AM, Peter Gelencser wrote:
>> I've run into a veird problem. I'm using a B400P BRI and an A1200P card
>> with dahdi (2.2.1) driver. The dahdi_scan shows the each moduls and
>> spans, everything seems fine. With dahdi_genconf I made the config, set
>> up the channels in chan_dahdi.conf, but after reboot, the two card
>> changes the order, (originaly the B400P is the first (closer to the
>> processor) and A1200P is the second), when I check with dahdi_scan, it
>> shows the channels are not in the original order. I set the Card ID
>> Switch to 0 on B400P but it does not solve the problem. I tried these
>> cards with another motherboard, the situation is the same so it's not
>> chipset specific.
>>
>> Please let me know if there is any solution. Thank you for your help in
>> advance.
>>
>
> Peter,
>
> I'm not familiar with the A1200P, but I suspect the A1200P not blacklisted in /etc/modprobe.d.  Therefore when you reboot, it's driver is loaded by udev before the rest of the DAHDI drivers are loaded.
>
> Try adding the driver for the A1200P to /etc/modprobe.d/dahdi.blacklist to make sure that the drivers are loaded by any configuration scripts in /etc/init.d in a consistent order.
>
> Cheers,

That was the solutions, thanks for the tip.


Best regards,
Peter Gelencser