[asterisk-users] [DAHDI 2.2.0.2] "failed on channel 1: No such device or address"
Vincent
vincent.delporte at bigfoot.com
Sat Nov 7 12:58:36 CST 2009
Hello
No matter if I use the entry-level OpenVox A400 with a single FXO
module or the most-often-garbage card from ww.x100p.com, I get the
following error after just adding this card to Mini-ITX with a single
PCI slot (OS = CentOS 5.4):
============
# lspci -v
03:00.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
Subsystem: Unknown device b100:0003
Flags: bus master, medium devsel, latency 64, IRQ 12
I/O ports at a000 [size=256]
Memory at e2000000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
============
# cat /proc/interrupts
CPU0 CPU1
0: 409671 0 IO-APIC-edge timer
1: 2 0 IO-APIC-edge i8042
7: 0 0 IO-APIC-edge parport0
8: 3 0 IO-APIC-edge rtc
9: 0 0 IO-APIC-level acpi
14: 7380 0 IO-APIC-edge ide0
15: 3406 0 IO-APIC-edge ide1
169: 122 0 IO-APIC-level uhci_hcd:usb5, HDA Intel
201: 0 0 IO-APIC-level ehci_hcd:usb1,
uhci_hcd:usb2
209: 0 0 IO-APIC-level uhci_hcd:usb3
217: 0 0 IO-APIC-level uhci_hcd:usb4
225: 333 0 PCI-MSI eth0
NMI: 0 0
LOC: 412563 419484
ERR: 0
MIS: 0
============
# cat /etc/dahdi/system.conf
loadzone=fr
defaultzone=fr
fxsks=1
============
# dahdi_cfg -vv
DAHDI Tools Version - 2.2.0
DAHDI Version: 2.2.0.2
Echo Canceller(s):
Configuration
-----------
Channel map:
Channel 01: FXS Kewlstart (Default) (Echo Canceler: none) (Slaves: 01)
1 channels to configure.
DAHDI_CHANCONFIG failed on channel 1: No such device or address (6)
============
If someone's already seen this error message, any idea what the cause
is, and what I could try to solve it?
Thank you for any tip.
More information about the asterisk-users
mailing list