[asterisk-users] Help: RED alarm on Wildcard TE122 card

[Oguzhan Kayhan]

Try to build a local loop cable first
Loop pins 1-4  and 2-5 and connect to e1 port of your card.
You should see the green light instead of red on card physically and ur
alarm should go green too
http://wiki.sangoma.com/Cablepinouts  check here for cable diagram




> Hi, I have been trying to get a Wildcard TE122 card running here the
> last couple of days.
>
> libpri and zaptel are all installed and configured to E1 specs. The
> jumper on the card is on, so configured for E1 (I'm in Norway).
>
> When running zttool, I get 'Alarms: RED' on the single card installed.
> Other information in zttool:
>  Current alarms: Red Alarm
>  Sync source: Internally clocked
>  IRQ Misses: 1
>  Bipolar viol: 0
>  Tx/Rx levels: 1/0
>  Total/conf/act: 31/31/0
>
> There are no IRQ conflicts (cat /proc/interrupt shows only wcte12xp0 on
> the relevant IRQ)
>
> The result is the same with or without cable inserted.
>
> The layout is:
>  TE122-[3m cable]-[~50m cable]-[NT1 ISDN box from Telenor]
>
> When inserting the cable going into TE122 into an ISDN phone, the phone
> works perfectly.
>
> Any suggestions would be greatly appreciated :-)
> _______________________________________________
> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users