[asterisk-users] Meetme Talker Optimization

[John A. Sullivan III]

On Mon, 2009-06-22 at 10:58 -0400, David Backeberg wrote:
> On Sat, Jun 20, 2009 at 8:15 PM, John A. Sullivan
> III<jsullivan at opensourcedevel.com> wrote:
> > Hello, all.  I've been playing with MeetMe and talker optimization
> > seemed like a great idea.  I activated it as follows:
> > exten => 201,1,MeetMe(100201,cTo)
> > No one can hear the talker.  It doesn't matter how loudly the talker
> > shouts! Is there something else I'm supposed to do to enable this? I am
> 
> Assuming that you don't have any other problems, as in a call between
> these parties outside of meetme, like with a Bridge() works just fine,
> you could have some problems specific to optimization. Specifically,
> look at dsp.conf and try tuning your silence threshold. If this is SIP
> I also recommend disabling vad / silence suppression.
> 
> In my experience, I had a lot of trouble with talker optimization and
> I turned it off completely. If you read the archives from the last few
> weeks you'll see further pointers I made on this topic, as well as
> links to a lengthy bugs.digium.com discussion on talker optimization.
<snip>
These are SIP connections so silence suppression may be the problem.  I
did also notice the threads and issues about talker optimization.  I was
hoping those were resolved in 1.6.1.1 - perhaps a bit naive.  Thanks -
John
-- 
John A. Sullivan III
Open Source Development Corporation
+1 207-985-7880
jsullivan at opensourcedevel.com

http://www.spiritualoutreach.com
Making Christianity intelligible to secular society