[asterisk-users] SPA3102 registration problem

[Jaap Winius]

Quoting Mandeep Singh Bhabha <mandeep.bhabha at dream-world.spb.ru>:

> 	what i did to configure SPA3102 is ...

My problem is that normal SPA3102 configurations just don't seem to  
work. I can't even get the FXS port to register. I'm beginning to  
suspect that my unit is defective. Here's why:

If I configure the FXS port to register with my Asterisk server using  
the most basic sip.conf configuration *without* a password, then it  
does actually register. The only problem is the address it gives:

    bitis*CLI> sip show peers
    Name/username              Host            Dyn Nat ACL Port     Status
    8000/8000                  127.0.0.1        D          5060     OK (1 ms)

That's right: instead of 192.168.1.8, it's telling Asterisk that it's  
available on the loopback address! I'll bet this is why it's not able  
to register using a password. I got the same results with three  
different firmware versions.

Still, it's an unusual way for a device to be broken. Could there be  
another reason for this behavior? Otherwise I'll just have to try to  
explain it to the vendor and perhaps to Linksys tech support and ask  
for my money back.

Cheers,

Jaap