[asterisk-users] Digium B410P: problematic Bri connection between * and a legacy Philips PBX

[Mr Shunz]

> Hi all,
>
[snip]

> For this reason I set all the 4 ports of Digium's card in NT mode
> (Philips can not do this). Then i opportunely
> edited /etc/misdn-init.conf and /etc/asterisk/misdn.conf. In fact, when
> I run the command "misdn shows stacks" in * CLI, I can see all ports in
> NT (PTP) mode.

have you tried to configure the ports in PTMP mode instead of PTP?
I found that for some PBX works better...

[snip]

> p.s.: I already attempt to change some options
> in /etc/asterisk/misdn.conf file. I tried to put
> incoming_early_audio=yes (explanation: Rarely used. If turned on, sends
> Tone Indications on TE Port for Incoming isdn channel. Normally the
> telcos send that informaton. By default is 'no'). It didn't work...

can you post your misdn-init.conf and misdn.conf?

cheers

-- 
------------------------------------------------
Daniele Santi       .o.
daniele at santi.vr.it ..o () ascii ribbon campaign
Linux User #415108  ooo /\ www.asciiribbon.org
------------------------------------------------