[asterisk-users] Zaptel wct2xxp driver causes LEDs to go black and RED alarm

[James Texter]

Have you checked to ensure the card in server #2 is jumpered for E1?

On Thu, 2007-06-21 at 09:34 -0500, Jason K. Carter wrote:

> Hi there,
> 
> I've got two Asterisk hosted PBX servers with Digium TE210P cards 
> attached by a E1 cable to Port 1 on each.  On startup, both cards flash 
> red, alternating between ports 1 and 2.
> 
> When server #1 loads the Zaptel  module and drivers, Port 1 status LED 
> goes green.  When server #2 loads the same module and drivers, Port 1 
> status LED goes completely blank.  Unloading the wct2xxp module causes 
> the flashing red LEDs to come back.
> 
> I've tried swapping cable ends and cards between the two machines, but 
> the problem LED always stays with server #2.  So, I think there is 
> something misconfigured with server #2, but the configuration file on 
> both servers is identical.
> 
> zaptel.conf:
> loadzone=uk
> defaultzone=uk
> 
> span=1,1,0,ccs,hdb3,crc4
> bchan=1-15,17-31
> dchan=16
> 
> span=2,0,0,ccs,hdb3,crc4
> bchan=32-46,48-62
> dchan=47
> 
> 
> Any clues what could cause a GREEN alarm on one end with a RED alarm on 
> the other and no LED light as soon as the wct2xxp driver is loaded?
> 
> Thanks for the help,
> Jason Carter
> DLS Internet Services
> 
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20070621/6a698d08/attachment.htm