[asterisk-users] X100P Woes

[Bob Smither]

I am out of things to try on getting an X100P card to work.

I have a P4 system with CentOS 5.1 installed (network install).  After
adding required packages I compiled (apparently successful) and
installed Zaptel in anticipation of installing Asterisk.

I simply cannot get the X100P card to be recognized.  I have tried bios
setting of PnPOS no and PnPOS yes, tried the card in different slots,
disabled all the unused motherboard devices to free up interrupts, etc.

The card works flawlessly in a CentOS 4.4 install on an old K6-2
motherboard.

If I put an ethernet card in a PCI slot (in addition to the one on the
motherboard), it is recognized and configured during boot so I assume
the interrupt hardware is working on the mother board.

I would really appreciate any suggestions of what I could try here.

Thanks!
-- 
Bob Smither <Smither at C-C-I.com>