[asterisk-users] Anyone here using JUNGHANNS.net douBRI 2.0 ISDN ?

[Tzafrir Cohen]

On Tue, Dec 04, 2007 at 01:25:53AM +0800, Elijah wrote:
> Hi, 
> 
> I'm very new to asterisk and managed to set one up in debian, I
> installed via apt-get the asterisk and asterisk-bristuff packages. I
> downloaded the bristuff source as well. 
> 
> I managed to get as far as loading the following modules: 
> zaptel                199144  4 cwain,zaphfc,zttranscode,ztdummy
> 
> But the problem now is that all channels that I try to configure gives
> me an error that that device/address doesn't exist ..and only one
> unconfigured device is displayed in zttool. 
> 
> 
> Does anyone have any experience with this type of card? care to share
> some tips? 
> 
> 
> 0c:02.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
> Controller [HFC-4S] (rev 01)
> Subsystem: Cologne Chip Designs GmbH Unknown device b556
> Flags: medium devsel, IRQ 5
> I/O ports at ccf8 [size=8]
> Memory at d9fff000 (32-bit, non-prefetchable) [size=4K]
> Capabilities: [40] Power Management version 2

In addition to the fact that you need qozap (and not zaphfc) as
mentioned before), you also probably need a newer version of qozap than
the one included in Etch. 

Try getting zaptel and zaptel-source from the etch backports at
pkg-voip.buildserver.net/debian or from updates.xorcom.com/rapid .

Should work well with the Asterisk packages in Etch, though I haven't
really tested it.

-- 
               Tzafrir Cohen
icq#16849755              jabber:tzafrir.cohen at xorcom.com
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir