[asterisk-users] Anyone here using JUNGHANNS.net douBRI 2.0 ISDN ?

[Stelios Koroneos]

For the HFC-4S (4 bri channels) you need to qozap driver not zaphfc

Regards

Stelios S. Koroneos

Digital OPSiS - Embedded Intelligence
http://www.digital-opsis.com


Quoting Elijah <elijah.alcantara at gmail.com>:

> Hi, 
> 
> I'm very new to asterisk and managed to set one up in debian, I
> installed via apt-get the asterisk and asterisk-bristuff packages. I
> downloaded the bristuff source as well. 
> 
> I managed to get as far as loading the following modules: 
> zaptel                199144  4 cwain,zaphfc,zttranscode,ztdummy
> 
> But the problem now is that all channels that I try to configure gives
> me an error that that device/address doesn't exist ..and only one
> unconfigured device is displayed in zttool. 
> 
> 
> Does anyone have any experience with this type of card? care to share
> some tips? 
> 
> 
> 0c:02.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
> Controller [HFC-4S] (rev 01)
> Subsystem: Cologne Chip Designs GmbH Unknown device b556
> Flags: medium devsel, IRQ 5
> I/O ports at ccf8 [size=8]
> Memory at d9fff000 (32-bit, non-prefetchable) [size=4K]
> Capabilities: [40] Power Management version 2
> 
> 
> 
> Regards, 
> Elijah 
> 
> 
> 
> 
> _______________________________________________
> --Bandwidth and Colocation Provided by http://www.api-digital.com--
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
> 




----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.