[asterisk-users] TDM400P Problem or Not?

[John Novack]

With a TDM 400 card in the system, WHY do you even need ztdummy??
I thought that was a substitute when there was no other timing source
The only time I have had to compile ztdummy is when there was NO card 
present.
Of course, I could be wrong. Please enlighten

John Novack



Eddie Johnson Jr wrote:
>
> Hello,
>
>  
>
> I am having a problem. I have aterisk1.2.11 installed on ubuntu server 
> 6.06 dapper and I have the ztdummy module listed in /etc/modules 
> directory however upon startup it will not load.
>
>  
>
> I type  lsmod | grep ztdummy and there is no output.  
>
>  
>
> I then ran a config file for asterisk to create startup config files 
> and it installs. 
>
>  
>
> I restarted the server with the newly installed files, and I type 
> asterisk and asterisk starts.  
>
>  
>
> I do this issue a command to connect remotely and receive the 
> connection and I type zap show status and I have the following:
>
>  
>
> Alarms                 IRQ                        
> bpviol                   CRC4
>
>  
>
> Wildcard TDM400P REV I Board                1 
>                              OK                          0 
>                               0
>
>  
>
> ZTDUMMY/1 1                                                  UNCONFUR  
>     0                              0                              0
>
>  
>
> I type stop now, go back to the prompt type mdprobe ztdummy and it 
> loads.  I repeat the above procedures above and I get the same message.
>
>  
>
> Any suggestsions?
>
>  
>
> Ed
>
>  
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>