[Asterisk-Users] IAX2 + port translation
Dr. Michael J. Chudobiak
mjc at avtechpulse.com
Fri May 26 08:33:54 MST 2006
Hi all,
I'm having trouble with incoming IAX2 calls on 1.2.7.1 - mostly they
work, but sometimes the caller just gets dead air or disconnects. IAX2
debugs show HANGUP and INVALID codes in these cases, rather than a
proper RINGING transaction.
My firewall is doing NAT, and changing the source port from 4569 to
something else - my IAX2 provider suggested this might be a problem. Is
it? Should this work:
steerpike*CLI> iax2 show registry
Host Username Perceived Refresh State
64.26.157.230:4569 8886708729 64.26.155.62:14353 60 Reg
64.26.157.230:4569 6134827945 64.26.155.62:14353 60 Reg
64.26.157.230:4569 6136866597 64.26.155.62:14353 60 Reg
64.26.157.230:4569 6136866675 64.26.155.62:14353 60 Reg
There are four DIDs, and all are registered to an odd port (14353). Is
this OK? (I am using a Sonicwall TZ170 with "Enable Consistent NAT" on).
- Mike
More information about the asterisk-users
mailing list