[Asterisk-Users] X100P fails to initialize

[John Novack]

Lachek Butalek wrote:

> So I took a chance with an X100P knock-off on eBay. I'm running 
> Asterisk + FreePBX on a PowerMac G3 (beige desktop) using Slackintosh 
> 10.2 and kernel 2.6.16.16 <http://2.6.16.16>. Everything has been fine 
> up until now.
> I compile the 1.2.5 Zaptel drivers without a problem, get the udev 
> configuration in, modprobe zaptel, and finally modprobe wcfxo. At this 
> point, I get the message:
>
> ZT_CHANCONFIG failed on channel 1: No such device or address (6)
> FATAL: Error running install command for wcfxo
>
> dmesg gives me:
>
> Zapata Telephony Interface Registered on major 196
> Zaptel Version: 1.2.5 Echo Canceller: MG2
> Failed to initailize DAA, giving up...
> wcfxo: probe of 0000:00:0e.0 failed with error -5
>
> syslog tells me:
>
> May 25 21:28:20 asterisk kernel: Failed to initailize DAA, giving up...
> May 25 21:28:20 asterisk kernel: wcfxo: probe of 0000:00:0e.0 failed 
> with error -5
>
> ztcfg -vv says:
>
> Channel 01: FXS Kewlstart (Default) (Slaves: 01)
> 1 channels configured.
> ZT_CHANCONFIG failed on channel 1: No such device or address (6)
>
> and lspci -vv tells me this:
>
> 00:0e.0 Communication controller: Motorola: Unknown device 5608
>         Subsystem: Motorola: Unknown device 0000
>         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> ParErr- Stepping- SERR- FastB2B-


On an Intel machine, it reports a Tigerjet chip.
Looks as if you may have the wrong modem chip?

John Novack