[Asterisk-Users] GXP2k and BLF problem
mustardman29
mustardman29 at hotmail.com
Thu May 25 15:11:26 MST 2006
I just tested my setup and the GXP2k re-registers according to the
registration expiration setting on it's GUI. I tried 1 min, 2 min, and 60
min. It all works as expected after an asterisk reboot.
GXP2k firmware 1.0.2.13, bootloader 1.0.2.3
Asterisk v1.2.7.1
> -----Original Message-----
> From: Lacy Moore - Aspendora [mailto:aspendora at gmail.com]
> Sent: Wednesday, May 24, 2006 1:00 PM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [Asterisk-Users] GXP2k and BLF problem
>
> Any chance there is a config file that they are reading? I
> know you have configured them manually, but I had a situation
> where I kept configuring one of my GXPs manually over and
> over, and it just would take the settings. I then found out
> I had a config file that it was reading.
>
>
> On 5/24/06, asterisk <asterisk at zinix.co.uk> wrote:
>
> See response from Grandstream below:
>
>
>
>
>
> Dear neil,
>
>
>
> We do not have such problem with * BLF. Please check
> your * configuration or consult online * forums.
>
>
>
> Best Regards,
>
> Cindy Li
>
> Grandstream Technical Support
>
>
>
>
>
> That was helpful wasn't it. We don't have a problem so
> your on your own.
>
>
>
> Ps. Can someone else check if setting the sip expiry
> time has any effect on these phones. Changed the timer to 1
> min on both of my phones and the * console still shows them
> logging in with a time of 60.
>
>
>
> fadge
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com>
> [mailto:asterisk-users-bounces at lists.digium.com ] On Behalf
> Of Lee Archer
> Sent: 24 May 2006 13:35
>
>
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
>
>
>
>
> Think you need to contact Grandstream support then.
> I've got the same version of * and GXP fw and I get no
> problems. Sorry I can't help you any further.
>
>
>
> Lee
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com [mailto:
> asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com> ] On Behalf
> Of asterisk
> Sent: 24 May 2006 13:30
> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
> Phone is manually configured through web interface.
>
>
>
> Thanks to all those who are helping with this.
>
>
>
> Fadge
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com>
> [mailto:asterisk-users-bounces at lists.digium.com ] On Behalf
> Of Lee Archer
> Sent: 24 May 2006 13:18
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
>
>
> Are you using preconfiged scripts? If so what happens
> if you manually config the phone then restart asterisk and
> then the phone?
>
>
>
> Lee
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com [mailto:
> asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com> ] On Behalf
> Of asterisk
> Sent: 24 May 2006 12:56
> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
> No,
>
> Rebooting the phones does not fix the
> problem. As previously stated the only way to get them
> working again is to default the config of the phone and rebuild.
>
>
>
> Fadge
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com>
> [mailto:asterisk-users-bounces at lists.digium.com ] On Behalf
> Of Lee Archer
> Sent: 24 May 2006 12:41
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
>
>
> I run 1.1.0.13 <http://1.1.0.13/> on my GXP's and
> after stopping and starting the server I either wait for the
> phones to re-reg or I reboot the phones. After restarting
> asterisk does rebooting the phones does fix the problem?
>
>
>
> Lee
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com [mailto:
> asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com> ] On Behalf
> Of asterisk
> Sent: 24 May 2006 12:25
> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
> Phones are configured for "asterisk BLF" . Like I said,
> the config works when the phone is defaulted and rebuilt but
> stops working if the server is rebooted. Show hints Gives:
>
>
>
> -= Registered Asterisk Dial Plan Hints =-
>
> 310 : SIP/310
> State:Unavailable Watchers 0
>
> 305 : SIP/305
> State:Idle Watchers 0
>
> 304 : SIP/304
> State:Idle Watchers 0
>
> 303 : SIP/303
> State:Idle Watchers 0
>
> 302 : SIP/302
> State:Idle Watchers 0
>
> 301 : SIP/301
> State:Unavailable Watchers 0
>
> ----------------
>
> - 6 hints registered
>
>
>
> Thanks
>
>
>
> fadge
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com>
> [mailto:asterisk-users-bounces at lists.digium.com ] On Behalf
> Of Lee Archer
> Sent: 24 May 2006 12:01
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
>
>
> Are the GXP's configured properly for BLF and what does
> show hints print?
>
>
>
> Lee
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com [mailto:
> asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com> ] On Behalf
> Of asterisk
> Sent: 24 May 2006 11:57
> To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
> It does not happen with a reload of asterisk but when
> the server is rebooted. I have set the register timeout to 1
> min but this has no effect. The BLF still does not work. The
> * is V 1.2.7.1 <http://1.2.7.1/> . I can see the phone
> register first time when phone reboots and would expect to
> see it re-register every 1 min on the console if I understand
> things correctly, but it does not.
>
>
>
> Fadge
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com>
> [mailto:asterisk-users-bounces at lists.digium.com ] On Behalf
> Of Lee Archer
> Sent: 24 May 2006 11:30
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: RE: [Asterisk-Users] GXP2k and BLF problem
>
>
>
> Stopping and restarting Asterisk will lose the hints,
> then you will have to wait until the phone registers again.
> With 1.2.7.1 <http://1.2.7.1/> a reload shouldn't lose
> anything. Change the register time on the phones to
> something less that 60 minutes if it's a big problem.
> Instead of factory defaulting the phones you might find a
> simple restart will re-register the phone and BLF will work
> on the phone.
>
>
>
> Regards
>
>
>
> lee
>
>
>
>
> ________________________________
>
>
> From: asterisk-users-bounces at lists.digium.com [mailto:
> asterisk-users-bounces at lists.digium.com
> <mailto:asterisk-users-bounces at lists.digium.com> ] On Behalf
> Of picciuX
> Sent: 24 May 2006 10:49
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [Asterisk-Users] GXP2k and BLF problem
>
> asterisk version? until 1.2.7.1 <http://1.2.7.1/> , sip
> subscriptions get lost on reload of asterisk. In this case,
> have to wait until phone re-registers and re-subscribe for BLFs...
>
> 2006/5/24, asterisk <asterisk at zinix.co.uk >:
>
>
> Hi,
>
> Is anyone else having problems with the Grandstream
> GXP2000 BLF? When I
> restart * the status lights stop working but the
> buttons still work as one
> touch dials and call the correct number. The only way I
> cen get the lights
> working again is to reset to factory default and
> re-build the config.
>
> I am running I upgraded the firmware to 1.1.0.13
> <http://1.1.0.13/> but still have the same
> problem.
>
> Any ideas ?
>
> Fadge
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com
> <http://easynews.com/> --
>
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>
> http://lists.digium.com/mailman/listinfo/asterisk-users
> <http://lists.digium.com/mailman/listinfo/asterisk-users>
>
>
> ###########################################
>
> This message has been scanned by F-Secure Anti-Virus
> for Microsoft Exchange.
> For more information, connect to http://www.f-secure.com/
>
> ###########################################
>
> This message has been scanned by F-Secure Anti-Virus
> for Microsoft Exchange.
> For more information, connect to http://www.f-secure.com/
>
> ###########################################
>
> This message has been scanned by F-Secure Anti-Virus
> for Microsoft Exchange.
> For more information, connect to http://www.f-secure.com/
>
> ###########################################
>
> This message has been scanned by F-Secure Anti-Virus
> for Microsoft Exchange.
> For more information, connect to http://www.f-secure.com/
>
> ###########################################
>
> This message has been scanned by F-Secure Anti-Virus
> for Microsoft Exchange.
> For more information, connect to http://www.f-secure.com/
>
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com
> <http://easynews.com/> --
>
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>
> http://lists.digium.com/mailman/listinfo/asterisk-users
> <http://lists.digium.com/mailman/listinfo/asterisk-users>
>
>
>
>
>
>
>
> --
> Lacy Moore
> Aspendora, Inc.
>
More information about the asterisk-users
mailing list