[Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP

[William Piper]

Sorry to hijack your thread.

Reading these posts made me grab my old MP-104 & try again to get it working
with asterisk.  I bought it a while ago off eBay & never could get it to
register. 

Does anyone have an example ini file for the MP-1XX that I could look at &
figure out what I am configuring wrong on this box?

Thanks,

bp

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jerry Jones
Sent: Wednesday, May 24, 2006 6:04 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP

 From my copy of the manual


MP-1xx SIP User's Manual  36 Document #: LTRT-65404
You can use the 'Reset' button to restore the MP-1xx networking  
parameters to their factory
default values (described in Table  4-1) and to reset the username  
and password.
Note that the MP-1xx returns to the software version burned in flash.  
This process also restores
the MP-1xx parameters to their factory settings, therefore you must  
load your previously backed-
up ini file, or the default ini file (received with the software kit)  
to set them to their correct values.
To restore networking parameters to their initial state, take these 6
steps:
1. Disconnect the MP-1xx from the power and network cables.
MP-1xx SIP User's Manual 4. Getting Started
2. Reconnect the power cable; the gateway is powered up. After  
approximately 45 seconds the
Ready LED turns to green and the Control LED blinks for about 3 seconds.
3. While the Control LED is blinking, press shortly on the reset  
button (located on the left side
of the front panel); the gateway resets a second time and is restored  
with factory default
parameters (username: "Admin", password: "Admin").
4. Reconnect the network cable.
5. Assigning the MP-1xx IP address (refer to Section  4.1 on page 35).
6. Load your previously backed-up ini file, or the default ini file  
(received with the software kit).
To load the ini file via the Embedded Web Server, refer to Section   
5.9.2.1 on page 120.




On May 24, 2006, at 3:00 PM, Erick Perez wrote:

> Just a question, has anyone knows how to blank or factory reset an
> AudioCodes MP124-C/FSX/AC/SIP unit (it's a 24 FSX to SIP unit).
> I purchased them second-handed with no manuals (thank god for the
> internet!!) but i guess the pdf manual I have does not have the
> section of factory-reset.
>
> Also, any sucess stories with:
> AudioCodes MP124-C/FSX/AC/SIP <--->Asterisk<---internet<--->Vonage   
> setups?
>
> Thanks,
>
>
> -- 
>
> -------------------------------------------
> Erick Perez
> Linux User 376588
> http://counter.li.org/  (Get counted!!!)
> Panama, Republic of Panama
> _______________________________________________