[Asterisk-Users] FXS Caller ID revisted

[Cosmin Prund]

Are you doing something funny with the CID on it's way to the phone? 
I've got a somewhat similar problem with an Aastra IP phone (yes, I did 
say IP): it would NOT ring if the caller id started with an "#". Maybe 
your Aastra PSTN phone got some of the same (buggy?) handling of CID's?

Dan Elder wrote:
> Hi All, posted last week but didn't get any responses. I'm trying to figure
> out why some of our analog phones aren't showing CID when hooked up to
> asterisk. To recap, I have an Aastra Powertouch 350, which shows caller ID
> fine when connected to the PSTN, but when hooked up to asterisk, CID does
> not show. I've hooked up another phone to the same * port that the Aastra
> phone is on, & it DOES show CID, so I'm assuming my settings & such are at
> least partially correct, can anyone point me to some options or areas I can
> look to troubleshoot this issue? Been pulling my hair out on this for days &
> just can't seem to get it sorted.
>
> I'm using asterisk 1.2.0 with a Carrier Access ABII channel bank. When
> another CID capable phone is hooke up to the same port, CID works fine, the
> Aastra phone is however unable to read the incoming CID from * apparently.
>
> Any pointers would be greatly appreciated, I've searched the Wiki & the CID
> faq's to no avail.
>
> Thanks in advance
>
> Dan
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>
>