[Asterisk-Users] Help with IRQ conflict between wct2xxp and eth0

[Kerry Garrison]

Go into the BIOS, disable every possible device such as floppy controller,
usb, serial, parallel, etc. If that doesn't work, move card to another slot.


> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com 
> [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of 
> Giorgio Incantalupo
> Sent: Friday, May 05, 2006 1:39 AM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [Asterisk-Users] Help with IRQ conflict between 
> wct2xxp and eth0
> 
> Hi Phil,
> may sound a stupid advice but....have you tried to change PCI 
> slots on your server?
> 
> Giorgio
> 
> Phil Menico wrote:
> >
> > I have a conflict problem with the eth0 card and wct2xxp 
> digium board. 
> > The PRI can receive calls but my network connection is gone.
> >
> > When I "cat /proc/interrupts" I get the following:
> >
> > 1 ..
> >
> > 1 ..
> >
> > ..
> >
> > ..
> >
> > ..
> >
> > 169 0 IO-APIC-level wct2xxp, eth0
> >
> > ..
> >
> > etc.
> >
> > even before I "modprobe wct2xxp"
> >
> > After I "modprobe wct2xxp" and "modprobe wctdm" and again run "cat 
> > /proc/interrupts"
> >
> > I then get:
> >
> >  
> >
> > ..
> >
> > ..
> >
> > ..
> >
> > ..
> >
> > ..
> >
> > 169 118489 IO-APIC-level wct2xxp, eth0
> >
> > 201 118497 IO-APIC-level wctdm
> >
> > ..
> >
> > etc
> >
> >  
> >
> > How can I force the wct2xxp to load on a separate IRQ? I 
> tried moving 
> > the eth0 to IRQ 10 but could not.
> >
> > Any ideas?
> >
> >  
> >  
> >
> > Thank you.
> >
> > _*/Phil Menico/*_
> >
> > XTEND Communications
> > 171 Madison Avenue, New York, NY 10016
> > 212-951-7632 (Office)
> > 212-951-7683 (Fax)
> > www.xtend.com
> >
> >      
> >
> > 
> ----------------------------------------------------------------------
> > --
> >
> > _______________________________________________
> > --Bandwidth and Colocation provided by Easynews.com --
> >
> > Asterisk-Users mailing list
> > To UNSUBSCRIBE or update options visit:
> >    http://lists.digium.com/mailman/listinfo/asterisk-users
> >   
> 
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>