[Asterisk-Users] TDM400 FXO module not answering or dialing out.

[Hadley Rich]

On Wednesday 22 March 2006 16:24, Hadley Rich wrote:
> I have hit a wall configuring a TDM400, I have set these up before without
> issue but today I just can't seem to figure out what I am doing wrong.
>
> On an incoming call the following is produced in the Asterisk console with
> verbose 4
>
>     -- Starting simple switch on 'Zap/2-1'
> Mar 22 16:12:34 NOTICE[2051]: chan_zap.c:6063 ss_thread: Got event 18 (Ring
> Begin)...
> Mar 22 16:12:34 NOTICE[2051]: chan_zap.c:6063 ss_thread: Got event 2
> (Ring/Answered)...
> Mar 22 16:12:37 NOTICE[2051]: chan_zap.c:6063 ss_thread: Got event 18 (Ring
> Begin)...
>     -- Executing Answer("Zap/2-1", "") in new stack
>     -- Executing Wait("Zap/2-1", "15") in new stack
> Mar 22 16:12:37 WARNING[2051]: chan_zap.c:3926 zt_handle_event:
> Ring/Off-hook in strange state 6 on channel 2
> Mar 22 16:12:38 WARNING[2051]: chan_zap.c:3926 zt_handle_event:
> Ring/Off-hook in strange state 6 on channel 2
>
> Asterisk doesn't answer the line. For debugging I have a POTS phone plugged
> into the line as well as the FXO and this phone continues to ring. The
> Answer and Wait are in the dialplan merely for debugging this problem.
>
> I cannot dialout via the FXO either, Asterisk appears to be doing
> everything correctly but never touches the line.
>
> I am running Asterisk 1.2.5 and Zaptel 1.2.4 on Kernel 2.6.15.6 with a
> TDM12B REV I

Please excuse the self reply but I missed some info from my original post.

The FXS module in the board works as expected - I can dial to and from it and 
SIP phones.

I have tried shifting the modules around the board and using the two different 
modules with the same result.

The card has it's own interrupt and zttest consistently gives 99.987793%

I have used another TDM card on this line with Kewlstart signalling and it 
worked correctly, this was with Asterisk 1.0.9 though.

Thanks again.

hads

-- 
He who is known as an early riser need not get up until noon.