[Asterisk-Users] Re: Linksys PAP2T-NA - call goes through but phone doesn't ring

[Stewart Nelson]

> I'm trying out a Linksys PAP2T-NA.  Calling out works great, no problems
> there.  Calling in, though, the phone doesn't ring.  Caller ID shows up, I
> can pick up the phone, and the call is connected, but no ring.  I've tried
> it on two analog phones, same behavior.  Suggestions?

I don't know if the T version is different.  On a PAP2, in Advanced View,
Regional tab, you can tweak Ring Frequency (default 25, try 20 and 30),
Ring Voltage (default 70, try 90) and Ring Waveform (default Sinusoid, try
Trapezoid).  Also, assuming you're not using distinctive ring, make sure
Ring 1 Cadence is 60(2/4) or something reasonable.  If still no luck,
you may have a bad SLIC; try the other port.  If all else fails, use a
scope to see what ringing voltage, if any, is present.  It's hard to
believe that this could be a * problem.

--Stewart