[Asterisk-Users] BN8S0 Installation problem - 0 devices registrered

[nik600]

hi
i am experiencing some problems with the configuration of an BN8S0 Beronet card.
I've downloaded last CVS of mISDN ans mISDNuser, i patch the kernel
2.6.16.18 and the enabled the following:

<*> ISDN support
  x x       Old ISDN4Linux  --->
  x x ---   CAPI subsystem
  x x <M>   CAPI2.0 support
  x x [*]     Verbose reason code reporting (kernel size +=7K)
  x x [*]     CAPI2.0 Middleware support (EXPERIMENTAL)
  x x <M>     CAPI2.0 /dev/capi support
  x x [*]       CAPI2.0 filesystem support
  x x ---     CAPI hardware drivers
  x x         Active AVM cards  --->
  x x         Active Eicon DIVA Server cards  --->
  x x         Modular ISDN driver  --->

 <M> Support modular ISDN driver
  x x [*]   Enable memory leak debug for mISDN
  x x [*]   Support for AVM Fritz!Cards
  x x [ ]   Support for HFC PCI cards
  x x [*]   Support for HFC multiport cards (HFC-4S/8S/E1)
  x x [*]     HFC multiport driver with memory mapped IO


after the kernel recompilation and the reboot i build and install
mISDNuser with make and make install.

The card is recognized by the system, this is the output of lspci:

00:0d.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
Controller [HFC-8S] (rev 01)

and i can load hfcmulti and mISDN_dsp without problems...
all channels are configured in TE mode, i use this modprobe:

/sbin/modprobe hfcmulti layermask=0xf,0xf,0xf,0xf,0xf,0xf,0xf,0xf
protocol=0x2,0x2,0x2,0x2,0x2,0x2,0x2,0x2 type=0x08
/sbin/modprobe mISDN_dsp

and this is the output of dmesg:

Modular ISDN Stack core $Revision: 1.34 $
mISDNd: kernel daemon started
mISDNd: test event done
mISDN: HFC-multi driver Rev. 1.41
0 devices registered
mISDN_dsp: Audio DSP  Rev. 1.17 (debug=0x0) EchoCancellor MG2
mISDN_dsp: DSP clocks every 64 samples. This equals 2 jiffies.


why i get 0 devices registrered? where am i wrong?
thanks in advance

nik