[Asterisk-Users] intel 536 EP as x100p clone?

[stevanus]

Hi..

I have one intel 536 EP. Does it possible use it as x100p clone for 
asterisk? I tried today with no luck :(..

Here is what I did :

- plugged the card
    the card is recognised as (lspci -vv):

00:09.0 Communication controller: Intel Corp. 536EP Data Fax Modem
        Subsystem: Intel Corp.: Unknown device 1000
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32, Cache Line Size 08
        Interrupt: pin A routed to IRQ 12
        Region 0: Memory at e2000000 (32-bit, non-prefetchable) [size=4M]
        Capabilities: [e0] Power Management version 2
                Flags: PMEClk- DSI- D1- D2+ AuxCurrent=375mA 
PME(D0-,D1-,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable+ DSel=0 DScale=0 PME-

- make and make install zaptel driver

- modprobe zaptel (there's no output)
- modprobe wcfxo and get these following messages:

ZT_CHANCONFIG failed on channel 1: No such device or address (6)
FATAL: Error running install command for wcfxo

Is there any possibilities using this card with asterisk?

I've searched wiki and there I found that people are success using Intel 
537EP as x100p clone.
While mine is merely Intel 536EP, but I think both are modems made by 
Intel..
Maybe there's a way making it function like x100p too like someone in 
asterisk channel (irc) told me :)..

Thanks..

Regards,

Stevanus